You are here: Forums SUVs Chevrolet Blazer Chevrolet Blazer Engine and Performance Problems

Chevrolet Blazer Engine and Performance Problems

142 messages,  Last post on Nov 11, 2009 at 9:09 PM

You are in the Chevrolet Blazer Forum. Your Hosts are steve_ & tidester

What is this discussion about? Chevrolet Blazer, SUV

Messages Page 13 of 15 1 ... 9 10 11 12 13 14 15 Prev Next Last

Go To Msg # Search This Discussion

#114 of 142 1998 Chevy blazer looses power and stalls by bigt442 May 22, 2008 (11:26 am)
I have a 1998 blazer that has had the fuel pump and filter replaced. It still seems to lack power and sometimes backfire or burp back thru the throttle body. fuel pressure seems to be with in tollerance, but have noticed a water leak at the back of the intake. So with that leak could a vacume leak cause it to run like this also. I have had a code that tells me that it is lean on bank 1 also. any help please. Replies to this message: jlflemmons (May 22, 2008 7:26 pm) sealteam8 (Oct 04, 2008 9:54 pm)
#115 of 142 Re: 1998 Chevy blazer looses power and stalls [bigt442] by jlflemmons May 22, 2008 (7:26 pm)
Replying to: bigt442 (May 22, 2008 11:26 am) Leaking intake manifold gasket, fairly common on these engines with high mileage.
#116 of 142 engine problem by fl2dv May 31, 2008 (7:37 pm)
i've been stalling alot after my blazer warms up.the warning light comes on and car wants to stall. i replaced the throttle position sensor but did not unhook the battery. would this cause my blazer to have hard starting now when i start my blazer? what should i do?
#117 of 142 1998 Chevy blazer stalls. by bigt442 Jun 01, 2008 (9:58 am)
I have a 1998 chevy blazer that I have now replaced the fuel pump and filter. I have also replaced the intake gaskets, mas air flow sensor and have tested all other sensors. All of them have check fine.The only other sensors to be check are the cam and crank. So now here is the problem, It will start but when you go to give it the gas it will stall out and then it may set a few moments before it restart. I am lost at what to do.
#119 of 142 2001 Blazer cyclinder 5 misfire by lincservices Sep 16, 2008 (2:31 pm)
2001 blazer 4.3 4wd - Repolaced fuel filter, air filter, plugs, cap, rotor, wires and oil change. No code until 15 minutes after getting to temp and then OBD gets a code for cyclinder 5 misfire. Would the coil cause this? Or do I need an injector. My mechanic stated that if I replace the injectors, I have to have a "spider" setup, but during research, there is no "spider" for that year, just the injectors and fuel pressure regulator.
#121 of 142 replaced fuel pump now rough idle high fuel pressure by johnyboy1 Oct 03, 2008 (3:40 pm)
hi,i have a 1999 blazer with 4.3L engine.the fuel pump went bad so i waited about 2 weeks then replaced it when i had the time.now the engine runs very rough and the exhaust is black and smells very sulfery.after driving it awhile i got the service engine light, the code reader shows p1133 and p1153.when i put a pressure gauge on the fuel rail test port it's reading 80-90 psi well above the 60-66 psi it should read. before the fuel pump went bad and i replaced it the car ran perfect.the manual i have for the car does not tell me what these odb codes mean. any help or ideas would be greatly appreciated
#122 of 142 Re: 1998 Chevy blazer looses power and stalls [bigt442] by sealteam8 Oct 04, 2008 (9:54 pm)
Replying to: bigt442 (May 22, 2008 11:26 am) The water leak shouldnt cause a vacum leak although it may! But the code lean on bank one tells me that the o2 sensor is bad, also check to make sure the firing order is right as well! The code says the o2 sensor in bank one is bad which means the sensor befor the cat. try replacing that one. there should only be 2 of them on that model
#123 of 142 97 Jimmy with a miss by tommyj2 Oct 08, 2008 (7:21 pm)
97 GMC Jimmy with a V6 Vortec, motor was bought from Advance and has around 40000 miles. I didn't put the motor in, it was already installed when I bought it. Hope someone can help me with this miss problem, I will try to explain it the best that I can. First off, new plugs, new plug wires, new coil pack, fuel filter and air filter. Catalytic converter has been removed. No Check engine light is on. The vehicle starts perfect and idles perfect, but when you go up a hill it sometimes has a bad hesitation like you are letting off the fuel back and forth, give it more gas and it quits. Then sometimes on flat ground at 55 mph it does the same thing. Sometimes I can pull into a parking lot at 3 mph or at an idle and the motor has a violent stutter to it. That has only happened twice. So can anyone enlighten me on this subject?? Replies to this message: sealteam8 (Oct 09, 2008 8:04 am) bowtie468443 (Oct 10, 2008 9:28 am)

Messages Page 13 of 15 1 ... 9 10 11 12 13 14 15 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums SUVs Chevrolet Blazer Chevrolet Blazer Engine and Performance Problems