You are here: Forums SUVs Chevrolet Blazer Chevrolet Blazer Engine and Performance Problems

Chevrolet Blazer Engine and Performance Problems

142 messages,  Last post on Nov 11, 2009 at 9:09 PM

You are in the Chevrolet Blazer Forum. Your Hosts are steve_ & tidester

What is this discussion about? Chevrolet Blazer, SUV

Messages Page 12 of 15 1 ... 9 10 11 12 13 14 15 Prev Next Last

Go To Msg # Search This Discussion

#108 of 142 95 Blazer electrical problem by jimbob11 Dec 30, 2007 (7:12 pm)
Have V-6 Vortec- When I turn on w/s wipers, they don't start right away and the radio turns off. There is a audible buzzing coming from the dash or the cowl area(drivers side).This lasts for about 10-15 seconds. After I turn the wipers on high, they will eventually turn on and the radio will come on also and the buzzing stops. Ever since I've had the vehicle, when I turned the wipers on intermittent, the radio would stop playing when the wipers came on, when they paused, the radio would play. Now the the buzzing problem. During all this, the battery never seems to go into discharge. Any suggestions on what to check? I have had no other known electrical issues.
#109 of 142 2000 GMC Jimmy 4.3 having problem with engine when it cold outside by tutto Feb 27, 2008 (3:33 pm)
Hi guys i have a problem with my truck when i start it in the morning and let it run for 5-10 min as soon as i put it in drive it starts bogging rpms jumping up and down does it until the engine get warm any idea guys i would appreciate it thanks
#110 of 142 Re: Chirping Gates serpentine belt fix [53jinx] by tommygemini Mar 09, 2008 (2:43 pm)
Replying to: 53jinx (Apr 10, 2007 5:25 am) I have been having belt noise since last June. I bought a belt from Pep Boys and they put it on because I was having problems getting it on. I think they charged me like $20 or $30 JUST to put it on and it took the guy like 3 minutes. Anyway, the noise barely went away. It had/has gotten worse the past few months. I would spray a lubricant on it every so often, but, the noise would come back in seconds. I tried belt dressing, against my better judgement, yeah it didn't work at all. DON'T USE BELT DRESSING ON SQUEAKY BELTS. Today I saw where you said you used silicone grease. I ran up to ace, bought some and put it on, it worked GREAT. I'm affraid tomorrow it will be back, but, we'll see. My belt is under warranty at Pep Boys, but, they will only exchange it, not refund my money. Why in the world would I want the same belt?!?! I was going to try a gatorback belt, but, I'm farely poor ha. So, I just hope the silicone grease works. Thanks!! Replies to this message: jlflemmons (Mar 10, 2008 8:02 pm)
#111 of 142 high idle on 97 blazer by horsey Mar 09, 2008 (6:19 pm)
I have a 97 Chevy blazer w/ V-6 Vortex engine. About a month ago it starting idling higher than normal until it warms up. When you are on icy roads and come to a stop sign, if the idle hasn't come down yet, it's like trying to stop with one foot on the brake and one on the gas, which isn't good!! The high idle eventually comes back down after awhile. One buddy though it might be the throttle positioning sensor and another buddy thought it might be the idle air control sensor. The check engine light doesn't come on though, so I was told I probably can't get a code. Anybody thoughts would be greatly appreciated.
#112 of 142 Re: Chirping Gates serpentine belt fix [tommygemini] by jlflemmons Mar 10, 2008 (8:02 pm)
Replying to: tommygemini (Mar 09, 2008 2:43 pm) I finally had to give up on the Gates belt and go with Goodyear. A trusted mechanic told me they have had problems with Gates serpentine belts chirping and squeaking. He said it is because the Gates has continuous grooves with no breaks and can trap oil and dirt.   Since I changed to the Goodyear belt I have had no noises in over 3 months. Seems to be fixed.
#114 of 142 1998 Chevy blazer looses power and stalls by bigt442 May 22, 2008 (11:26 am)
I have a 1998 blazer that has had the fuel pump and filter replaced. It still seems to lack power and sometimes backfire or burp back thru the throttle body. fuel pressure seems to be with in tollerance, but have noticed a water leak at the back of the intake. So with that leak could a vacume leak cause it to run like this also. I have had a code that tells me that it is lean on bank 1 also. any help please. Replies to this message: jlflemmons (May 22, 2008 7:26 pm) sealteam8 (Oct 04, 2008 9:54 pm)
#115 of 142 Re: 1998 Chevy blazer looses power and stalls [bigt442] by jlflemmons May 22, 2008 (7:26 pm)
Replying to: bigt442 (May 22, 2008 11:26 am) Leaking intake manifold gasket, fairly common on these engines with high mileage.
#116 of 142 engine problem by fl2dv May 31, 2008 (7:37 pm)
i've been stalling alot after my blazer warms up.the warning light comes on and car wants to stall. i replaced the throttle position sensor but did not unhook the battery. would this cause my blazer to have hard starting now when i start my blazer? what should i do?
#117 of 142 1998 Chevy blazer stalls. by bigt442 Jun 01, 2008 (9:58 am)
I have a 1998 chevy blazer that I have now replaced the fuel pump and filter. I have also replaced the intake gaskets, mas air flow sensor and have tested all other sensors. All of them have check fine.The only other sensors to be check are the cam and crank. So now here is the problem, It will start but when you go to give it the gas it will stall out and then it may set a few moments before it restart. I am lost at what to do.

Messages Page 12 of 15 1 ... 9 10 11 12 13 14 15 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums SUVs Chevrolet Blazer Chevrolet Blazer Engine and Performance Problems