Sign In Join 



Chevrolet Blazer Engine and Performance Problems

142 messages,  Last post on Nov 11, 2009 at 9:09 PM

You are in the Chevrolet Blazer Forum. Your Hosts are steve_ & tidester

What is this discussion about? Chevrolet Blazer, SUV


Messages Page 11 of 15
1
...
8
9
10
11
12
13
14
15
Prev
Next
Last
Go To Msg #
Search This Discussion

#101 of 142
93 chevy blazer engine problems? by chriscwb
Nov 03, 2007 (9:42 pm)
Reply
When I go to take off it doesnt want to go and it will bog down and or stall,and when I start goin down the road it sometimes does not want to shift and then sometimes it will not go over 2,000 rpms and i will only be going about 50 mph.When the truck is just sitting in park I can rev it up and everything and it will do fine,sounds good and every thing but when I go to take off all that happens.Also when I start it white smoke comes out of the tail pipe any suggestions,I have checked fuel filter,injectors,plugs,coil but nothing any info and I would appreciate it thanks
#102 of 142
95 blazer misses when warm by grose69
Nov 08, 2007 (9:19 am)
Reply
have a 95 Blazer with 185000 miles on the original Vortec V-6. Lately I have noticed the engine running poorly after it gets warmed up. I just changed the plugs, wires,cap rotor and O2 sensor. None of this seems to have helped. When you first start the engine, it runs as smooth as the day it was built. After about 30 minutes, the miss starts. I have also noticed a significant drop in fuel mileage as well. Any ides?
#103 of 142
97 Blazer acceleration issues by wm1210
Nov 09, 2007 (10:08 am)
Reply
I have a 97 Blazer with 140K on it and it has been having some acceleration and performance issues. At times the acceleration is very sluggish and then it at other times it is normal. The sluggishness tends to be more pronounced when the fuel tank is full and then occurs less when the tank is below half. I recently had a tune-up and had the fuel pump replaced, but the sluggishness still exists. My mechanic indicates that the computer is not throwing any codes and hesitates to guess at replacing any parts. Does anyone have any thoughts? Thanks!
#104 of 142
New Engine noise by cincyblazer
Nov 10, 2007 (11:34 am)
Reply
Just today, my 2002 2-Dr blazer began making an engine knock at startup. Once the Engine temp reaches 210, the noise stops. I have also noticed that the oil pressure guage fluctuates while driving. Does anyone have any ideas.
#105 of 142
Re: New Engine noise [cincyblazer] by jlflemmons
Nov 15, 2007 (3:09 pm)
Reply

Replying to: cincyblazer (Nov 10, 2007 11:34 am)

Low oil???
 
How many miles on the engine?
#107 of 142
2002 Chev. Blazer 4.3 S-Belt Tensioner by utmo23
Nov 15, 2007 (6:06 pm)
Reply
How much movement should there be in the tensioner and when should it be replaced?
#108 of 142
95 Blazer electrical problem by jimbob11
Dec 30, 2007 (7:12 pm)
Reply
Have V-6 Vortec- When I turn on w/s wipers, they don't start right away and the radio turns off. There is a audible buzzing coming from the dash or the cowl area(drivers side).This lasts for about 10-15 seconds. After I turn the wipers on high, they will eventually turn on and the radio will come on also and the buzzing stops. Ever since I've had the vehicle, when I turned the wipers on intermittent, the radio would stop playing when the wipers came on, when they paused, the radio would play. Now the the buzzing problem. During all this, the battery never seems to go into discharge. Any suggestions on what to check? I have had no other known electrical issues.
#109 of 142
2000 GMC Jimmy 4.3 having problem with engine when it cold outside by tutto
Feb 27, 2008 (3:33 pm)
Reply
Hi guys i have a problem with my truck when i start it in the morning and let it run for 5-10 min as soon as i put it in drive it starts bogging rpms jumping up and down does it until the engine get warm any idea guys i would appreciate it thanks
#110 of 142
Re: Chirping Gates serpentine belt fix [53jinx] by tommygemini
Mar 09, 2008 (2:43 pm)
Reply

Replying to: 53jinx (Apr 10, 2007 5:25 am)

I have been having belt noise since last June. I bought a belt from Pep Boys and they put it on because I was having problems getting it on. I think they charged me like $20 or $30 JUST to put it on and it took the guy like 3 minutes. Anyway, the noise barely went away. It had/has gotten worse the past few months. I would spray a lubricant on it every so often, but, the noise would come back in seconds. I tried belt dressing, against my better judgement, yeah it didn't work at all. DON'T USE BELT DRESSING ON SQUEAKY BELTS. Today I saw where you said you used silicone grease. I ran up to ace, bought some and put it on, it worked GREAT. I'm affraid tomorrow it will be back, but, we'll see. My belt is under warranty at Pep Boys, but, they will only exchange it, not refund my money. Why in the world would I want the same belt?!?! I was going to try a gatorback belt, but, I'm farely poor ha. So, I just hope the silicone grease works. Thanks!!

Messages Page 11 of 15
1
...
8
9
10
11
12
13
14
15
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement