You are here: Forums SUVs Ford Explorer Ford Explorer Cruise Control

Ford Explorer Cruise Control

5 messages,  Last post on Nov 07, 2007 at 5:43 PM

You are in the Ford Explorer Forum. Your Hosts are steve_ & tidester

What is this discussion about? Ford Explorer, SUV

Messages Page 2 of 2 1 2 Prev Next Last

Go To Msg # Search This Discussion

#2 of 5 Re: Explorer cruise control [puuhina] by kiawah Oct 01, 2007 (3:11 pm)
Replying to: puuhina (Oct 01, 2007 3:08 pm) You can try to buy a 2 day online subscription to helminc.com. They have Ford service manuals, and a 2 day subscription is very reasonable. Not sure how many years they go back, but check them out.
#3 of 5 Re: Explorer cruise control [puuhina] by moterboat Oct 02, 2007 (1:47 pm)
Replying to: puuhina (Oct 01, 2007 3:08 pm) disconnect battery,remove the two screws holding the air bag on,unplug it,turn airbag upside down,remove the four screws holding the back of the airbag togeather,then remove the switch. this is from the ford tech disc I have from ford..althou I have never seen one go bad,the clock spring and the GEM module is what useally goes bad that would effect the cruise.. Replies to this message: puuhina (Oct 02, 2007 4:20 pm) sundance2007 (Nov 07, 2007 5:43 pm)
#4 of 5 Re: Explorer cruise control [moterboat] by puuhina Oct 02, 2007 (4:20 pm)
Replying to: moterboat (Oct 02, 2007 1:47 pm) Mahalo (Thanks) for the reply. It works OK, but the surface is badly deteriorated and damaged. Does the horn/bag cover just pry off exposing the screws? I bought the vehicle used but in pretty good shape otherwise. (41k miles) Replies to this message: sundance2007 (Nov 07, 2007 5:43 pm)
#5 of 5 Re: Explorer cruise control [puuhina] by sundance2007 Nov 07, 2007 (5:43 pm)
Replying to: puuhina (Oct 02, 2007 4:20 pm) puuhina,   The manual I have (for my 95 Ford Explorer) says to disconnect the batt. and on the side of the steering wheel are two plugs that cover the two bolts that hold the airbag module in place.   I need to replace the RSM switch on my cruise control. I got a switch on Ebay but it has 6 pins and my switch has 7 Do you know how to determine the if the 6 pin switch will work?   Thanks

Messages Page 2 of 2 1 2 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums SUVs Ford Explorer Ford Explorer Cruise Control