You are here:
Forums
Pickups
Toyota Tacoma
Toyota Tacoma Tire Pressure Sensors

18 messages, Last post on Oct 08, 2009 at 5:17 PM
You are in the Toyota Tacoma Forum. Your Host is kcram
| I plan on buying a second set of wheels for my Tacoma. How much is a set of pressure sesnsors? I am not sure what Toyota charges? is there after market sensors that can be bought? By the way its a 2007 Tacoma 2wd 4cyl that I have. | |
|
|
|
Replying to: tacoman05 (Sep 28, 2007 6:11 am) |
|
|
I recently had a blow out and put on my spare and left my tire at the shop to be replace while I went to work. If the tire is somewhere else, you will still get a low pressure signal. Does that make sense? Also, you may have to hit the reset button on the bottom of the dash under the steering wheel. Also, my ex-wife drove my truck last year for a day trip a had a flat. A nice man helped her put two cans of Fix-a-Flat in the tire to allow her to get home. Fix-a-flat destroyed the sensor and I had to have it replaced. I think the sensor was about $80 bucks and about $45 to have the dealership install and activate it to my trucks computer. Ouch! |
|
|
Hi guys, I need a little help here. I have 2007 Tacoma prerunner. The tire pressure sensor went on when I was driving. I just saw it as steady light. I followed the manual to put pressure at 29 PSI for front and rear per manual. When i tried to reset it, it blink 3 times and still come to steady light. When I turn the engine on , it just blink once and come steady. Please help. I'm not sure if the sensors are ,malfunctioning. Note: I did not check my spare tire. Thanks. |
|
| Hi Folks, My tire pressure light was on so I took it to the dealers. It was out for 3 days, then it got cold and came on solid. I checked the pressure in the tires and they were off so I put 30lbs in each tire (including the spare). Now the light blinks. What is the exact reset procedure that you have to do to make this stupid light go out. | |
|
|
|
Replying to: hannaspop (Jan 03, 2009 1:42 pm)
|
|
|
Replying to: buffalonickel (Jan 03, 2009 6:06 pm) |
|
| Is there anyway to disconnect the TPS so that the light doesn't flash on the board? | |
|
Replying to: buffalonickel (Jan 03, 2009 6:06 pm) "11. Tire Pressure Warning System The tire pressure warning valve and transmitter has been discontinued on the spare tire. Alternatively, an information label indicating “TEMPORARY USE ONLY” has been placed on the spare tire disc wheel. The spare tire for the ’09 Toyota Tacoma is only for temporary use. Do not perform tire rotations on the spare tire." So I could see how adding some Fix-a-Flat could gunk up the valve/transmitter. For the guy who bought the new aluminum wheels, could you take your old valve assemblies and put them on your new wheels? Just a thought. My 2008 Tacoma will definitely set off the low tire pressue light when the spare gets too low. Airing it up will shut the light off. The valve sensors do seem to work well. I hope I can make the same statement when my truck gets 10-12 years on it!
|
|
|
Replying to: nussbaum (Oct 07, 2009 6:06 pm) |
|
You are here:
Forums
Pickups
Toyota Tacoma
Toyota Tacoma Tire Pressure Sensors
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2011 Toyota Tacoma



Browse by Board
Browse by Topic
Today's Chats