You are here: Forums Vans & Minivans Chevy Venture Stubborn 2nd row seats

Stubborn 2nd row seats

5 messages,  Last post on Feb 24, 2008 at 6:12 AM

You are in the Chevy Venture Forum. Your Host is Karens

What is this discussion about? Chevrolet Venture, Chevrolet Chevy Van, Van

Messages Page 2 of 2 1 2 Prev Next Last

Go To Msg # Search This Discussion

#3 of 5 purchasing conversion van seating by sashdave Jan 28, 2008 (6:00 am)
Does anyone have websites where I can go to purchase the third seat sofa bed combo for my 2004 GMC Savana?
#4 of 5 Re: Stubborn 2nd row seats [chases] by 442dude Jan 29, 2008 (5:22 am)
Replying to: chases (Oct 22, 2007 2:17 pm) Correct!!!! If someone forced it in there's only one way to get it out...force it out. Couple of good whacks with a hammer will fix it. You may also want to put a little WD40 on the mounts just to make it move a little easier.
#5 of 5 Move the seats around anywhere in van by atherton Feb 24, 2008 (6:12 am)
Having a 2001 Venture LT with the three separate middle seats and the solid one-piece bench third-row seat, I found that the spacing for all the seats was the same. Just take the rear seat or seats out competely, (make a couch in your garage).      Now you can put any of the middle seats in the rear, put just two seats on one side, one behind the other, so there is a long flat 7-foot stretch down the other side, or remove one of the seats from the middle and put just one seat in the rear on one side, etc. There is almost unlimited interchangability, as far as spacing of the seats, ONCE YOU REMOVE THOSE STUDS with a dremel tool cut-off tool for instance. Take notice that some combinations will preclude using the shoulder harness, but if you move a second-row seat to the same side in the rear, you are ok, and the middle seat has a regular seat-belt which can be used if kept on the side where the clip belongs. REMOVING the studs does not mean the seats won't fit where they were originally, and have all the original functions, just that you can put any seat anywhere. By cutting off one side of the stud, close to the seat frame, the stud can be punched all the way out of the hole (hammer and nail-set) and you will never miss it again.

Messages Page 2 of 2 1 2 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Vans & Minivans Chevy Venture Stubborn 2nd row seats