- #57 of 66
-
Re: 2006 JGC Limited Quadra-drive 2 "service 4WD System message" [jaynote99]
by ffalkner
-
Apr 21, 2009 (7:57 am)
-
|
|
Replying to: jaynote99 (Jul 19, 2008 4:57 am)
I have a 2005 JGC that experienced the same message. The dealer replaced a defective sensor in the front differential to solve the problem. Thank goodness I had the warranty.
|
- #60 of 66
-
Re: Radio reception not working and alarm for door locking system [snsanborn]
by 4x4jeep
-
Jul 03, 2009 (9:52 pm)
-
|
|
Replying to: snsanborn (Jul 03, 2007 6:43 am)
generally if you loose the ability to control the radio with steering controls, verify that none of the controls are stuck engaged. simple way to do that is to try the same operation at the radio itself. if you still can not preform the function, then something else is messed up. if you find that the operation works at the radio then one of the buttons on the steering wheel controls is stuck. simply pull out the control switch from the wheel and disconnect the 2 wire connection and check if you can use the controls at the wheel to control the radio. if you can just replace that rocker switch. good luck
|
- #61 of 66
-
Re: Optimus Radio a MINimus [pastortom]
by 4x4jeep
-
Jul 03, 2009 (9:59 pm)
-
|
|
Replying to: pastortom (Apr 07, 2009 3:39 pm)
sounds like a grounding issue, you can always add a ground to the actual radio and it will not hurt anything, that should solve your problem. or check your ground wire on the harness see what kind of ohms you are getting. the factory ground for the harness i believe is in the center council next to the airbag module. good luck
|
- #62 of 66
-
Re: speakers [brad423]
by 4x4jeep
-
Jul 03, 2009 (10:03 pm)
-
|
|
Replying to: brad423 (Aug 31, 2007 4:05 am)
it is possible the wires are loose in the back of the steerio or something is rubbing, when the dash is installed at the factory the radio is already in the dash and they slam it home. the wires or bundles could be hitting the dash superstructure. check out the harness for routing and wire heath when you pull the radio out. good luck
|
- #63 of 66
-
Re: resetting computer after service [ptahrek]
by 4x4jeep
-
Jul 03, 2009 (10:06 pm)
-
|
|
Replying to: ptahrek (Oct 11, 2006 5:39 pm)
another meathod is to push the throttle down to the floor 3 times when you first turn on the ignition. if it registers the jeep will beep at you and then turn off the message. good luck
|
- #64 of 66
-
Re: OEM Navigation modification off doad use only [coolrider]
by 4x4jeep
-
Jul 03, 2009 (10:11 pm)
-
|
|
Replying to: coolrider (Jun 24, 2007 3:17 pm)
unfortunitely that can only be done by software change.
|
- #65 of 66
-
Re: 2002 Grand Cherokee Stock Audio System [chaseavec]
by 4x4jeep
-
Jul 03, 2009 (10:17 pm)
-
|
|
Replying to: chaseavec (Jun 20, 2007 10:40 pm)
to the best of my knowledge that answer is no, your steering controls use 6 different voltages to preform there function, so i am not sure how you can use them for tieing into any rear seat modifications good luck
|
- #66 of 66
-
fuses
by papa10
-
Sep 03, 2009 (1:13 pm)
-
|
|
Turn signals and air conditioner quit while driving down road. Any ideas, Fuses?
|