You are here: Forums Pickups Chevrolet S-10 & GMC S15 Sonoma Chevy S10 - GMC S15 and Sonoma Vibrations

Chevy S10 - GMC S15 and Sonoma Vibrations

35 messages,  Last post on Aug 16, 2009 at 8:26 AM

You are in the Chevrolet S-10 & GMC S15 Sonoma Forum. Your Host is kcram

What is this discussion about? Chevrolet S-10, GMC Sonoma, Truck

Messages Page 3 of 4 1 2 3 4 Prev Next Last

Go To Msg # Search This Discussion

#16 of 35 Re: Fuel pump problems [gonogo] by ohiaboy May 30, 2008 (12:05 pm)
Replying to: gonogo (May 30, 2008 8:22 am) well i was driving up a hill and when i stopped at the light and went to take off as soon as i let off the clutch and gave it gas it died and would not start. when i pulled it to a nearby parking lot i smelled burned wires. so far ive trace the fuel pump relay, replace the pump and sending unit. the only thing i havent replaced is the oil pressure switch. and from what i understand like i said before it works as a shut off for the fuel pump. Replies to this message: gonogo (May 31, 2008 7:04 am)
#17 of 35 fuel problems by ohiaboy May 30, 2008 (12:11 pm)
i know that on the pump there is a purple wire(to the fuel gauge) and a grey wire(to the pump). the oil pressure switch is right next to the oil filter, its sticking out so you cant miss it lol.but i think im going to replace it and see if that fixes the problem if not its one of the wires coming from the switch, i just wish i had a diagram. or knew which fuse in the fuse box works the fuel pump....anyone know? Replies to this message: gonogo (May 31, 2008 7:17 am)
#18 of 35 Re: Fuel pump problems [ohiaboy] by gonogo May 31, 2008 (7:04 am)
Replying to: ohiaboy (May 30, 2008 12:05 pm) Burned wire smell, sounds like a short.
#19 of 35 Re: fuel problems [ohiaboy] by gonogo May 31, 2008 (7:17 am)
Replying to: ohiaboy (May 30, 2008 12:11 pm) Have no information for a 93 fuses, no decal on the cover. On the later ones the pump fuse is ECMB.
#20 of 35 s10 problem by tdg2123 Jul 26, 2008 (7:22 am)
i have an 01 s10 xtream and around 32 mph til about 36 mph theres a real bad vibration ...i changed all 3 u joint and the main shaft bearing but it still there ...i dont think its the tranny because i shifted it man. through the gears and felt it in 2ond 3erd and drive ..it goes away after 36 but i can kinda feel it at about 65 again not as much ....could it be the converter or mabye the rear ? ...i took it to a place and they said that the shaft was balanced but the could have been b.s.in   anyone else have a prob like this ?? Replies to this message: hoodlatch (Jul 26, 2008 6:59 pm)
#21 of 35 Re: s10 problem [tdg2123] by hoodlatch Jul 26, 2008 (6:59 pm)
Replying to: tdg2123 (Jul 26, 2008 7:22 am) I had a low speed vibration on my S-10 which turned out to be a bracket to the catylitic converter heat shield.
#22 of 35 Rear End Vibration 93 Sanoma... by jbzzzzo Aug 04, 2008 (4:26 pm)
I have new rims and tires, new shocks, drive shaft balanced with new u-joints, even tried new brake shoes and drums....So I assume my axle might be bent. Its not a major vibration, but enough to be anoying. Its a 2 wheel drive so not the CV. If anyone has any thoughts.........or just go ahead with new axles? Then the truck will be practicly brand new. I just rebuilt the engine and painted the truck. I'm ready to be done with it!!! Replies to this message: hoodlatch (Aug 07, 2008 6:40 pm)
#23 of 35 Re: Rear End Vibration 93 Sanoma... [jbzzzzo] by hoodlatch Aug 07, 2008 (6:40 pm)
Replying to: jbzzzzo (Aug 04, 2008 4:26 pm) Short of hitting a culvert or being in an accent of some kind how does one bend an axle on a S10?
#24 of 35 bent axle?? 93 sanoma by jbzzzzo Aug 08, 2008 (4:17 pm)
My sister-in-laws brother did beat the crap out of it before I owned it..so its hard tellin what he did. I did put it on jack stands and put it in gear. The right side did move up and down about a half an inch and wobbled sided to side slightly. Is that normal. The left side was'nt as bad. Im gona spend $200 on a buffer and buff out my paint job before I spend any more on my....rear end...HA!! Any other suggestions besides taking in to a shop. Replies to this message: hoodlatch (Aug 08, 2008 8:18 pm)
#25 of 35 Re: bent axle?? 93 sanoma [jbzzzzo] by hoodlatch Aug 08, 2008 (8:18 pm)
Replying to: jbzzzzo (Aug 08, 2008 4:17 pm) Sometimes a slipped belt on a tire will cause a bad vibration.

Messages Page 3 of 4 1 2 3 4 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Pickups Chevrolet S-10 & GMC S15 Sonoma Chevy S10 - GMC S15 and Sonoma Vibrations