You are here: Forums Vans & Minivans Chevy Venture Venture Engines

Venture Engines

26 messages,  Last post on Jan 05, 2009 at 3:26 PM

You are in the Chevy Venture Forum. Your Host is Karens

What is this discussion about? Chevrolet Venture, Pontiac Montana, Oldsmobile Silhouette, Van

Messages Page 3 of 3 1 2 3 Prev Next Last

Go To Msg # Search This Discussion

#21 of 26 Re: CODES [davis911s] by davis911s Dec 19, 2008 (1:48 pm)
Replying to: davis911s (Dec 09, 2008 3:00 pm) Ok I have changed all the plugs (the back ones are a pain in the butt) Changed EGR Valve Changed fuel filter   Still same symptoms it starts and runs real rough then dies   What is next step? Replies to this message: 442dude (Jan 04, 2009 8:05 am) russ23 (Jan 04, 2009 12:24 pm)
#22 of 26 heating and cooling by caperguy4u Jan 04, 2009 (5:18 am)
I have a 1997 venture that is heating up on the gauge and sometimes breaks loose and i will get some heat coming out of the heat vents but most times just cold air. I had the thermostat replaced along with heat sensor and radiator flushed. No sign of water in oil and no white smike from exhaust. Replies to this message: rkarch (Jan 05, 2009 10:04 am) russ23 (Jan 05, 2009 3:26 pm)
#23 of 26 Re: CODES [davis911s] by 442dude Jan 04, 2009 (8:05 am)
Replying to: davis911s (Dec 19, 2008 1:48 pm) PO172 is engine running too rich   PO300 is random misfires detected.   Sounds like a bad ignition control module to me or fuel system issue (injector or system pressure)   I would start by checking those 2 areas in that order   Good Luck...
#24 of 26 Re: CODES [davis911s] by russ23 Jan 04, 2009 (12:24 pm)
Replying to: davis911s (Dec 19, 2008 1:48 pm) Troubleshooting the Venture engine is not simple a matter of changing a few components. The factory service manual is several hundred pages long and tough to read. I would first suspect a blown intake manifold gasket or cylinder head gasket(s). If you have oil pressure problems, loss of coolant, and/or overheating that is where I would go before the computer system. I landed up changing out my engine with a junkyard engine. Runs fine now. If you need more email me direct: lloydballardhotmail.com.
#25 of 26 Re: heating and cooling [caperguy4u] by rkarch Jan 05, 2009 (10:04 am)
Replying to: caperguy4u (Jan 04, 2009 5:18 am) Had the same problem. Ended up being a head gasket. Lots of money to fix. I used STEEL SEAL cost me $80.00 and it is still working 2 months later. I average about 400 miles per week on my 2000 Venture. I had no signs of water in coolent or blowing smoke just constant high pressure in cooling system. Hope this helps. Replies to this message: russ23 (Jan 05, 2009 3:26 pm)
#26 of 26 Re: heating and cooling [rkarch] by russ23 Jan 05, 2009 (3:26 pm)
Replying to: rkarch (Jan 05, 2009 10:04 am) Could you clarify your symptoms? Think you meant to say no oil in coolant or vise versa? Also what do you mean by high pressure in cooling system? I think you mean the coolant was boiling over? I am tucking your suggestion to use Steel Seal away incase my engine acts up again. It appears to have a small leak that may be triggering a check engine light for a catylatic converter problem.

Messages Page 3 of 3 1 2 3 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Vans & Minivans Chevy Venture Venture Engines