You are here: Forums SUVs Nissan Murano Nissan Murano Power Seat Problem

Nissan Murano Power Seat Problem

88 messages,  Last post on Nov 23, 2009 at 2:10 PM

You are in the Nissan Murano Forum. Your Hosts are steve_ & tidester

What is this discussion about? Nissan Murano, Car Safety, SUV

Messages Page 9 of 9 1 ... 3 4 5 6 7 8 9 Prev Next Last

Go To Msg # Search This Discussion

#79 of 88 Re: Nissan Power Seat Issue [skippy7024] by steelflatroll Oct 12, 2009 (6:16 pm)
Replying to: skippy7024 (Apr 03, 2008 5:21 am) can you another gear I would gladly paid you I am having hard time trying to find one in the junk yards Replies to this message: beresde (Oct 20, 2009 10:09 am) steelflatroll (Oct 20, 2009 10:29 am)
#80 of 88 Re: Nissan Power Seat Issue [steelflatroll] by beresde Oct 20, 2009 (10:09 am)
Replying to: steelflatroll (Oct 12, 2009 6:16 pm) my wife has 2005 Murano and I had the same issue. found a replacement gear at http://www.odometergears.com/infiniti.html only $64.00 with shipping, only took me 15 minutes to install and Nissan wanted $800 for a new seat. I had to email odometergears a picture of the gear and they advised the infiniti gear would fit and it did! so it has been two weeks since I replaced it and no issues....Hope this helps a few of you out there. Replies to this message: steelflatroll (Oct 20, 2009 10:29 am)
#81 of 88 Re: Nissan Power Seat Issue [beresde] by steelflatroll Oct 20, 2009 (10:29 am)
Replying to: beresde (Oct 20, 2009 10:09 am) Great and thank you a bunch ...this was getting harder to find in a junkyard and I been waiting for a machine shop to tell what it would cost to make one . I am not paying 700 for this part , which like you said it only took 15 mins to do ... I do have pictures of it and I just send it off to the email address you gave me --- again thank you ....
#82 of 88 power seats by steelflatroll Nov 04, 2009 (2:21 pm)
thanks beresde .... I got the gear and it works fine   I now have another issue with the seat there seems to be maybe a coin in the track causing it to go only part way back when I get to that spot it turns side way I dont push in fear I may strip the new gear . I looked at the track and cant figure out how a coin could get in there ? or is this something other than something in the track that I am experiencing ? ANY IDEALS OUT THERE or am I just going have to remove the seat altogether ? Replies to this message: featon (Nov 06, 2009 12:07 pm) steelflatroll (Nov 06, 2009 12:26 pm) featon (Nov 07, 2009 3:52 am)
#83 of 88 Re: power seats [steelflatroll] by featon Nov 06, 2009 (12:07 pm)
Replying to: steelflatroll (Nov 04, 2009 2:21 pm) Hi steel. I picked up that same gear and for the life of me I can't figure out where it goes. Would you help a hapless and seatless Murano owner out by explaining the installation of that gear?   Thanks a lot, featon Replies to this message: steelflatroll (Nov 06, 2009 12:26 pm) featon (Nov 07, 2009 3:52 am)
#84 of 88 Re: power seats [featon] by steelflatroll Nov 06, 2009 (12:26 pm)
Replying to: featon (Nov 06, 2009 12:07 pm) to be sure driver right side as you sit in the seat is what I had   1 -raise seat   2 -remove 3 screws covering a plate in front of track   3- when open you'll see a nut remove this take note of how gear the comes off along with where the washer are located   4 line up new gear if hard to pushed on you can either sandpaper the rounded entry side by rolling sand paper up to fit and smooth out just a bit ( not too much ) I did this and still was tight so I used a deep well socket and tap it in the rest of the way take note of the oval side and make sure its line up with the stud before tapping in   5 reverse order to close it up its fairly simple I think   Good Luck and let me know how you make out Replies to this message: featon (Nov 07, 2009 3:52 am)
#85 of 88 Re: power seats [steelflatroll] by featon Nov 07, 2009 (3:52 am)
Replying to: steelflatroll (Nov 06, 2009 12:26 pm) Bingo! Following your steps made installing the gear a breeze. I greatly appreciate you taking the time to help me. Thank you.   featon
#86 of 88 Re: Nissan Power Seat Issue [03muranosl] by razzvan1976 Nov 22, 2009 (4:14 pm)
Replying to: 03muranosl (Aug 14, 2007 10:15 am) The same thing happend to me. I have an 07 murano, my drivers side seat broke. I went to the dealer, they want $746.00 . I ended up welding it, but yesterday it broke again. If i would have know this problem with the driver's seat, i would have bought the ford edge! Replies to this message: svofan2 (Nov 23, 2009 2:10 pm)
#87 of 88 Re: Nissan Power Seat Issue [razzvan1976] by svofan2 Nov 23, 2009 (2:10 pm)
Replying to: razzvan1976 (Nov 22, 2009 4:14 pm) ..why wasn't this problem covered under the 3 year/3600 warranty?....your MO is only an 07

Messages Page 9 of 9 1 ... 3 4 5 6 7 8 9 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums SUVs Nissan Murano Nissan Murano Power Seat Problem