You are here:
Forums
Sedans
Oldsmobile Intrigue
Oldsmobile Intrigue Starting/Stalling

107 messages, Last post on Oct 28, 2009 at 10:45 AM
You are in the Oldsmobile Intrigue Forum. Your Hosts are pat & karens
|
I'm getting a p0340 camshaft sensor circuit malfunction. Replaced sensor,wires,and crankshaft sensor just to make sure.No luck |
|
|
Replying to: olds409 (Aug 22, 2009 3:21 am) |
|
|
Replying to: dtownfb (Aug 26, 2009 5:12 pm) |
|
|
Replying to: dtownfb (Aug 26, 2009 5:12 pm)
|
|
|
Replying to: olds409 (Aug 31, 2009 1:00 pm) What was the exact code? Here's a discussion on the crankshaft sensor: http://www.automotiveforums.com/vbulletin/showthread.php?t=961719&highlight=star- t It turns out the connecting wires to the sensor were bad which resulted in the code.
|
|
|
Replying to: dtownfb (Sep 02, 2009 9:12 am) |
|
Ok,i'm getting a P0340 cam sensor circuit malfunction and a P0335,p0385 crank sensor A and B circuit malfunction.My car wont crank.I have replaced,ignition switch,lock and cilinder,cam sensor,crank sensor,neutral safety switch.connector,pig tails,batery,pcm.And still nothing,It has power on the small wire to starter.However Im tired of spending $$$$.Could this be the answer to my problem?
|
|
|
|
|
Replying to: olds409 (Oct 17, 2009 8:51 am) this is the wire to the solenoid after all the checks like sensor park neutral etc. If it has power from this wire to ground when turning the key but no crank, then the solenoid or the starter is the issue. There are two coils in the solenoid to engage the heavy spring loaded lever to pull in the main contact to the starter. Once the main contact is in the second coil is cut out of the circuit and the remaining coil is sufficient to hold it in until you release the key. Verify that you have a good ground to the starter. It is through the bolts to the block, which is grounded by a big ground wire somewhere.
|
|
|
Replying to: moonshadow (Oct 18, 2009 5:44 pm) |
|
| Ok guys, after all I did to my Olds,he let me down.Finaly fixed the starting problem,and now the torque converter clutch is stuck. It start but the second you put it in gear it stalls. Picked up a 04 Grand Prix,same car ,same problems,well not yet.... Question?Can I swap starters?The one in the olds is 7days old.Acording to autozone they have the same part number except for the gp has an "s"Will it fit?Maybe some shims? | |
You are here:
Forums
Sedans
Oldsmobile Intrigue
Oldsmobile Intrigue Starting/Stalling
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2002 Oldsmobile Intrigue



Browse by Board
Browse by Topic
Today's Chats