Geo Prizm Restoration - READ ONLY

11 messages,  Last post on Dec 03, 2008 at 6:46 PM

You are in the Chevrolet (Geo) Prizm - Archived Discussions Forum.

What is this discussion about? Chevrolet Prizm, Sedan

#10 of 11 Re: Engine Block Removal by Prizm265508

Dec 01, 2008 (12:03 pm)

Also It is not even attempting to turn over I turn the key and nothing, I know it seized because it did not have oil in it the night it seized. I was about to put some in at the next gas station but the car did not make it that far.

#11 of 11 Re: Engine Block Removal [Prizm265508] by alpiner

Dec 03, 2008 (6:46 pm)

Replying to: Prizm265508 (Dec 01, 2008 12:03 pm)
Most equipment rental stores have engine lifters. They slide right under the front of your car and have a hydraulic piston that lifts the boom arm. Get it all ready to lift out and get one...5minutes and it's out. This engine should have lifting eyes still attached. Before you start anything, remove the battery. If your friend has a shop, he has a lifter.
 
I know it;s too late now, but if any of you Prizm ownners are reading this, you need to check your oil(weekly) and change it promptly as shown in your manual. They use oil! Some more than others.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement