You are here: Forums Sedans Hyundai Sonata Hyundai Sonata Timing Belt

Hyundai Sonata Timing Belt

6 messages,  Last post on May 21, 2008 at 5:21 AM

You are in the Hyundai Sonata Forum. Your Hosts are pat & karens

What is this discussion about? Hyundai Sonata, Sedan

Messages Page 1 of 1 All Messages Displayed

Go To Msg # Search This Discussion

#1 of 6 Timing belt by gajeca1929 Jul 02, 2007 (11:22 am)
Hi.. Have a question. I have replaced the Timing belts on my Sonata 2000 2.4lts engine.I have stricly followed the Belts installing information.But when i got to the timing marks.It kind of confussesd me a bit.As of the Oil Pump Timing.It stated that there is a plug that has to be removed,In order to be able to push a screw driver in.But icannot take the plug out as it is badly corroded.I just wanted to know .Why does the oil pump needs to be timed.I never saw this before on any other engine.Please a reply would helpwith any information.Thank You Replies to this message: hytech (Apr 04, 2008 3:58 pm) lazarus319 (May 21, 2008 4:15 am) gajeca1929 (May 21, 2008 5:21 am)
#2 of 6 expert by gajeca1929 Jul 03, 2007 (4:14 pm)
Where are all the Sonata Expert?.Or are there any Sonata experienced Mechanics!!.On this Forum. Replies to this message: pat (Jul 04, 2007 9:48 am)
#3 of 6 Re: expert [gajeca1929] by pat HOST Jul 04, 2007 (9:48 am)
Replying to: gajeca1929 (Jul 03, 2007 4:14 pm) You could try posting in the Technical Questions discussion. It's not vehicle specific, but someone there might be able to give you some ideas.
#4 of 6 Re: Timing belt [gajeca1929] by hytech Apr 04, 2008 (3:58 pm)
Replying to: gajeca1929 (Jul 02, 2007 11:22 am) the balance shaft has one setting/mark but the oil pump which is to the right of thecrank when looking at the eng, it has three positions when u line it up to the mark it will return down ,turn it then set it will pull up,turn and set again and when it is released it should return to the mark even if it is moved up or downand released,and when you are done with the belt spin the motor and for every 3 complete cycles the balace should line up that is 6 crank revolutions or 3 cam revolutions
#5 of 6 Re: Timing belt [gajeca1929] by lazarus319 May 21, 2008 (4:15 am)
Replying to: gajeca1929 (Jul 02, 2007 11:22 am) What's the mileage that you changed the belt out at? Replies to this message: gajeca1929 (May 21, 2008 5:21 am)
#6 of 6 Re: Timing belt [lazarus319] by gajeca1929 May 21, 2008 (5:21 am)
Replying to: lazarus319 (May 21, 2008 4:15 am) changed belt at 144580 Kilometers.It would of still not have to be replaced at that mileage.But my Son was driving it.Must of got some water contamination in the gas tank.It Backfire once and started but was missing a lot.Have it running now ,Replaced the two Belts,Crank Censor.Cam Censor,Water pump,and all the Pulleys and Belts Adjuster,Also replaced & Coill pack.Darn Transistor kept on Burning out,But found the problem,Was whoever had installed the AutoStart device.Had the ground wire not installed properly and got hot and burned some of the wires bundle that it was that it was bundled with it.Thank You for Asking.These Sonata are Amazing CarStill have it ,But i have purchased a Sister of it.A KIA Magentis what a luxury machine this is.

Messages Page 1 of 1 All Messages Displayed

Go To Msg # Search This Discussion

You are here: Forums Sedans Hyundai Sonata Hyundai Sonata Timing Belt