Ask the Car People.SM


Chevy Blazer Acceleration, Electrical or Fuel Problem

29 messages,  Last post on Aug 10, 2012 at 11:00 PM

You are in the Chevrolet Blazer Forum.

What is this discussion about? Chevrolet Blazer, GMC Jimmy, Fuel System, Electrical, SUV

    

Messages Page 3 of 3

#20 of 29 blazer lacks power by 2se

Jan 19, 2008 (3:56 pm)

i press on the accelerator and it goes up to about 2000 rpm slowly to 3000 rpm then it just goes down slowly i changed the catalyst just about a day ago and recently did a tune any suggestion will be greatly accepted

#21 of 29 replaced ecm now wont run by barneyb

Feb 08, 2008 (6:06 pm)

98 blazer vortec 4.3 just replaced ecm and fuel filter now start but stalls imediatly.can spray starting fluid in it runs until fluid is gone then dies.can anyone tell me what to check.motor is used and it ran fine until i had to replace computer due to the fact that my gauges were not working.

#22 of 29 Re: replaced ecm now wont run [barneyb] by chopper7

Feb 13, 2011 (7:09 am)

Replying to: barneyb (Feb 08, 2008 6:06 pm)
see if the ecm needs to be flash

#23 of 29 99 Jimmy Idle Issues by salb833801

Feb 13, 2011 (2:29 pm)

Hi, I drive a Jimmy and I started noticing that when I'm doing between 35 to 55 miles an hour the rpm's start to go wild. The muffler is making a weird sound too. can that be the issue? Any ideas anyone?

#25 of 29 92 chevy s-10 blazer by jbuchert

Nov 16, 2011 (7:58 pm)

ok so heres the deal im doing some bassically charity work for some of the elderly in the communtiy yay for me right lol anywho so so thia truck was running ok but not well enough to pass emmisions so i gave it a tuneup adjusted the timing it was purring like a kitten the lady hits the highway to go have emmmisions done and boom it starts backfiring running rough all that good stuff so i ran the code it says ignition control module and o2 sensor i replaced them both started the trucki and it runs worse than when i started so as now im baffled i chexck the fuel pressure it say 58lbs and instantly dtrops and i mean drastically so i assume fuel pressure regulator wrong replaced it same prob any suggestions

#26 of 29 Re: 92 chevy s-10 blazer [jbuchert] by steve_ HOST

Nov 18, 2011 (6:41 pm)

Replying to: jbuchert (Nov 16, 2011 7:58 pm)
Still backfiring?
 
Try the Got a Quick, Technical Question discussion or Edmunds Answers.

#27 of 29 Runs rough when cold by jimbob24

Dec 05, 2011 (12:42 am)

My 99 Blazer miss when i crank it when it is cold, it usually fires right up but lately it has been getting harder to fire up. After it warms up it runs fine, i have noticed just before it shift into second and third gear it miss real bad but when it shift it runs fine. When it gets to normal temp it runs great. A scan shows that no. 4 cyl is missing, once it said multiple cyl were missing. It has new plugs,wires,cap,rotor,fuel filter, i have checked or replaced the egr,pcv,maf, checked for leaks at intake, tb. Help, i dont where to look next.

#28 of 29 NO DASH LIGHTS by pjean64

Mar 15, 2012 (9:45 am)

Well actually the dash lights do come on but not without the dome light!! I have a 2002 Chevy Blazer, 4 dr.. if this helps.. Tried not turn the dial too far but didn't work. I've looked in manual but there's nothing. Help please

#29 of 29 Blazer 2000 4.3L problem by hih

Aug 10, 2012 (11:00 pm)

My tuck is a Blazer 2000 4.3L and has 120,000 km on the clock, it is in generally in good condition, the problem is that when the truck is cold, it doesn’t start. The only way I can start it is by adding petrol/gas directly into the carburetor. The other issue I have is the car is lacking power. When I drive at low revs these is no problem, however. At when I step on the accelerator, nothing happens. It is as if I didn’t do anything.
Please help.

Messages Page 3 of 3

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement