You are here:
Forums
Pickups
Dodge Dakota
Dodge Dakota Towing Questions

18 messages, Last post on Sep 21, 2009 at 7:43 AM
You are in the Dodge Dakota Forum. Your Host is kcram
| I own an 01 STL c/cab. It has a factory installed tow bar and 7 pole connector. I use a 4 wire adaptor for the lights on my boat trailer. The ground wire (wht) is attached to the trailer. I recently rewired the trailer and checked all connections, they were fine. However in the dark I (tryed to) hooked up the 4 wire adaptor backwards (dopey me!) witnessed a small flash in my tail lights and since that time I no longer have running lights on the trailer. The stop and turn signals work OK. I have removed and checked all fuses in the two fuse blocks (underhood and dash side panel) described in the O/M. All fuses check OK w/ a meter. Can anyone tell me if there is a in-line fuseable link or another fuse block that services the factory trailer connection. I checked the wiring under the truck and cannot detect any breaks or shorts. Any solutions or other suggestions? | |
|
Replying to: ffloyd (Jan 08, 2008 9:15 pm) |
|
|
I just purchased a 2009 dodge dakota 4x4 and plan to tow 4 wheels down behind my motorhome. the owner's manual says to disconnect the battery which of course will preclude towing as then brake lights, turn signals etc. wouldn't work. Does anyone know what happens if anything if one leaves the battery hooked up? Moel
|
|
|
Replying to: moel (Sep 20, 2009 3:42 pm) What you don't want to do, in general, is have two batteries connected together in parallel. This is why I think you're being told to remove the battery.
|
|
|
Replying to: srs_49 (Sep 21, 2009 3:34 am) |
|
You are here:
Forums
Pickups
Dodge Dakota
Dodge Dakota Towing Questions
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Dodge Dakota



Browse by Board
Browse by Topic
Today's Chats