68 messages,
Last post on May 19, 2013 at 3:57 AM
You are in the
Dodge Stratus Forum.
What is this discussion about?
Dodge Stratus, Engine, Sedan
#63 of 68 Re: engine removal [dustin32393]
by mizjakio
Apr 10, 2012 (11:43 am)
take the front pin out and drop it through the bottom....
#64 of 68 Re: Stratus conking out
by jonmicon
Sep 13, 2012 (9:46 pm)
I have a 1999 Stratus as a standby but lately the engine cuts out without any apparent cause. I've replaced the fuel pump, the computer and a couple of sensors but after I drive it for a half hour, it just stops and I have to wait an hour before it will restart again. It seems like something happens when the motor gets warmed up, but it doesn't overheat, either. A lot of people seem to have this same problem but who has the solution.
#65 of 68 Re: Stratus conking out [jonmicon]
by mfrance
Feb 18, 2013 (5:32 pm)
it might be cam position sensor, had that similar problem on another car and that fix it
#66 of 68 wont start, dodge stratus 1999
by mfrance
Feb 18, 2013 (5:38 pm)
fuel pump is working, spark plugs are getting fire, and i put #1 piston in tdc and lined up the marks on the cam pulleys, cant figure it out
#67 of 68 Re: 2001 Stratus 3.0L Misfire [ncmich]
by mfrance
Feb 18, 2013 (6:24 pm)
need to check your exhaust converter if it is stopped up it will give that reading on the codes
#68 of 68 Engine will not start 2003 DOHC Sedan
by ronsuper1
May 19, 2013 (3:57 am)
Just replaced timing belt on a 2003 DOHC Sedan, Timing is dead on, have spark and compression but cranks like no spark plugs are in it. How do I find out if this is an interference engine?