You are here: Forums Sedans Chrysler Cirrus Chrysler Cirrus Starting/Stalling Problems

Chrysler Cirrus Starting/Stalling Problems

27 messages,  Last post on Dec 03, 2009 at 7:11 PM

You are in the Chrysler Cirrus Forum. Your Hosts are pat & karens

What is this discussion about? Chrysler Cirrus, Sedan

Messages Page 3 of 3 1 2 3 Prev Next Last

Go To Msg # Search This Discussion

#21 of 27 Re: 2000 cirrus engine died while on driving on the freeway [wallymaven] by spencers225 Aug 11, 2009 (10:00 am)
Replying to: wallymaven (Aug 08, 2009 7:53 am) I had a mobile mechanic come out to my house and he replaced the curcuit that the fuel pump relay fuse plugs into. this seemed to fix the problem, but i was on my way back home from california and the car started blowing fuses left and right. I probably went through over 30 fuses just to get the car back to Las Vegas. It sounds like when the curcuit was wired it wasn't wired correctly, but the guy was just here yesterday and he says everything checks out fine. I would check the fuel pump relay fuse. Your curcuit could have blown just like mine did. Replies to this message: tommy666 (Oct 23, 2009 5:57 pm)
#22 of 27 Re: 2000 cirrus engine died while on driving on the freeway [spencers225] by tommy666 Oct 23, 2009 (5:57 pm)
Replying to: spencers225 (Aug 11, 2009 10:00 am) Tell me about it. I baught my 95 cheap cuz I was out of work but it's turning into a monry pit. The first time I sent it to a shop right away They said oil was leaking from my spark plugs and causing a conduit for crossfire which destroyed my distributer. I got one from a salvage yard which my shop bench tested a found it was bad. $1,200.00 later new plugs, wires, and gaskets and my car breaks again. I changed gaskets and used dialectric grease done the work myself. Seemed to work for a while but the car died again. I poured 2 gal of water over the hot engine waited 5 minutes and the car started but ran rough at first. Seems to be a heat problem. After further insp. the cooling fans were not coming on. I put in freeon and the fans came on only when AC is on. I changed Coolant sensor and fan work good. The car still stalls. I checked thermostat and water pump, all good. The problem is definately eletrical and I'm guessing sensor so dont go buying computers I'll try cam shaft sensor and will get back to ya. Tommy
#23 of 27 My Car keeps dying on me!! PLEASE HELP? by wattsgirla Nov 11, 2009 (7:14 pm)
PLEASE HELPOk I have 99' Chrysler cirrus, that i have just replaced the crank shaft position sensor, idle air control, and EGR valve, and its still not fixed. The rpms will go crazy, oil light & cruise control light comes on, and it will stall, but sometimes it will run for and hour or two with no problems but other times its irraitic..I have heard it may be plugs/wires, distubotor cap, coil pack,cam sensor,and battery(just bought a new battery).. Tired of the guessing game.. Ready to junk this POS!!! Any suggestions, would be greatly apprecitated.. 2 hours ago - 4 days left to
#24 of 27 My Car keeps dying on me!! PLEASE HELP? by wattsgirla Nov 15, 2009 (9:13 am)
Well i took my 99' Chrysler Cirrus to the dealership and found out that the crank postion sensor, was a bad one and that i have oil leaking down my distubutor shaft, replacing that sensor has takin care of some of the problem, but my oil light still comes on along with service engine soon light..taking back to the dealer Monday..
#25 of 27 1998 Cirrus won't start by wjsandy Dec 03, 2009 (11:32 am)
1998 Cirrus V6. 48,000 miles. No problems until now. Pulled into garage one night and won't start next day. No Spark. No codes set with test from Actron tester. Check all fuses. All OK. ASD voltage is correct. ASD relay checks OK with ohm meter. Replaced distributer with remanfactured. Still won't start. Testing crankshaft position sensor. 8 volts on unit (Orange wire) but no fluctuating voltage on output of sensor (Grey/Black wire). Bad sensor?? ($72.00 to buy) and look like a real bear to change. Could it be ECM? Thanks Replies to this message: cirriousissues (Dec 03, 2009 7:07 pm)
#26 of 27 Re: 1998 Cirrus won't start [wjsandy] by cirriousissues Dec 03, 2009 (7:07 pm)
Replying to: wjsandy (Dec 03, 2009 11:32 am) Have you checked the fuel pump? (I have a '97 V6 with 77,000 and it went out recently)...
#27 of 27 The common stalling problem... by cirriousissues Dec 03, 2009 (7:11 pm)
1997 V6 - 77,000 miles. It has been stalling mostly when I come up to a light or stop sign, coasting in general. So far I have replaced: distributor cap, spark plugs, wires, CAM sensor, Crankshaft Sensor (is that the same?), both belts, MAP sensor, my fuel pump was replace 10 months ago...   What is next? I have heard maybe the idle air flow sensor? I know this is a common problem...has anything helped?

Messages Page 3 of 3 1 2 3 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Sedans Chrysler Cirrus Chrysler Cirrus Starting/Stalling Problems