You are here: Forums SUVs Pontiac Aztek Pontiac Aztek Traction Control & Antilock Brakes

Pontiac Aztek Traction Control & Antilock Brakes

74 messages,  Last post on Nov 14, 2009 at 5:51 PM

You are in the Pontiac Aztek Forum. Your Hosts are steve_ & tidester

What is this discussion about? Pontiac Aztek, SUV

Messages Page 8 of 8 1 2 3 4 5 6 7 8 Prev Next Last

Go To Msg # Search This Discussion

#70 of 74 Re: Who knows what the issue is??? [dalejrnut74] by ray80 Nov 13, 2008 (4:18 am)
Replying to: dalejrnut74 (Nov 12, 2008 6:31 am) The grinding ar low speeds (with the addition of turns being involved) is usually indicative of fron wheel bearing issue . When they replace the hub/bearing assembly they also are replacing speed sensor (comes as part of assembly) and that may resovle anti-lock problem. Replies to this message: fartblossom (Oct 26, 2009 8:00 am) buster51 (Nov 06, 2009 3:51 pm)
#71 of 74 Re: Who knows what the issue is??? [ray80] by fartblossom Oct 26, 2009 (8:00 am)
Replying to: ray80 (Nov 13, 2008 4:18 am) O.K., The grinding/bumping noise is definately the abs kicking in. This problem just started on our 03. 6 months ago I had the hubs replaced for the traction warning lights coming on. The light doesn't come back on, but now the growling/pedal slip while braking and turning has started.   I fixed it temporarily by pulling the ABS fuse. Sure enough, all problems gone. Unfortunately, the alarm bell never quits. Knowing that all GM bells/alarms are fed through the radio, I pulled the fuse for the radio too, now all is well. Of course, warning lights are still on and you don't get any warning when you leave your keys in the car.   I plan on inspecting the harness next weekend. Replies to this message: buster51 (Nov 06, 2009 3:51 pm)
#72 of 74 Re: Who knows what the issue is??? [fartblossom] by buster51 Nov 06, 2009 (3:51 pm)
Replying to: fartblossom (Oct 26, 2009 8:00 am) I just discovered this sight because I am having the same issues with my 2001. i have owned this car since new and this is the first major puzzling problem I have had other than the gas gauge since I bought it. I have 145,000 miles on it. It sounds to me that there is no clear answer to this problem. Money is tight so where would yoy all reccomend starting out? I took it to a shop and they told me it was because my rotors were warped so they turned the rotors and the problem is still there. They talked about it being some control module that runs $1000 just for the part. Thanks Mike
#73 of 74 Re: Who knows what the issue is??? by 34chevy Nov 10, 2009 (12:28 pm)
my Aztek is FWD with 90K; therefore problem was limited to the drive wheels. Drivers side ABS sensor wire was broken at junction of larger harness likely a fatigue failure. $.35 worth wire connectors, electrical tape have corrected the problem. Just for the record I replaced wheel bearings at 61,000 because of noise that my wife could hear. Hope this helps someone before spending big bucks at dealership. Replies to this message: buster51 (Nov 14, 2009 5:51 pm)
#74 of 74 Re: Who knows what the issue is??? [34chevy] by buster51 Nov 14, 2009 (5:51 pm)
Replying to: 34chevy (Nov 10, 2009 12:28 pm) Thank you for your input. A freind and I tore the harness apart near the ABS box but could not see any damaged wire. Was yours pretty obvious. The next step is to get a code reader and check the warning code. Probably will repace sensors next. Any other thoughts by anyone.   Thanks Mike

Messages Page 8 of 8 1 2 3 4 5 6 7 8 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums SUVs Pontiac Aztek Pontiac Aztek Traction Control & Antilock Brakes