You are here: Forums Pickups Dodge Dakota Dodge Dakota Stalling and Dying Problems

Dodge Dakota Stalling and Dying Problems

68 messages,  Last post on Nov 05, 2009 at 4:17 PM

You are in the Dodge Dakota Forum. Your Host is kcram

What is this discussion about? Dodge Dakota, Truck

Messages Page 7 of 8 1 2 3 4 5 6 7 8 Prev Next Last

Go To Msg # Search This Discussion

#56 of 68 Re: 2002 3.9l Dodge Dakota with automatic transmission that stalls in reverse. [dustyk] by mrsincere7 Mar 26, 2009 (4:04 pm)
Replying to: dustyk (Mar 26, 2009 2:00 pm) It may have been more severe as it got closer to winter with the old IAC. However since I replaced it with a new one, everything is smooth as silk even though we are still experiencing cold temps. Truck runs like it's brand new regardless of the temp. My buddy who replaced his IAC ( with a new one ) on his 01' Dakota has the same positive results. It was his results that prompted me to replace mine after cleaning my old IAC didnt last. I guess if the IAC is several years old, it's probably worth replacing it rather than cleaning it.
#57 of 68 Re: Stalling [cmccurdy] by moparlover3 Apr 25, 2009 (6:25 pm)
Replying to: cmccurdy (Feb 26, 2008 7:42 am) More than likely the crankshaft position sensor as mine seems to have gone and the symptoms seem the same but really a hard part to remove without patience and proper tools. Not too much room to work between the firewall and engine and transmisssion. I've just recently obtained a used one from the wreckers and it worked for all of about a couple of hours the died on the highway again. So now I think I'll spend the bucks and get a new oem replacement and see how long that one lasts?
#58 of 68 1992 5.2 engine problems by moparlover3 Apr 25, 2009 (6:36 pm)
I've owned my 1992 dakota 4x4 5.2 since new and haven't experienced too many problems until recently. It has 192000kms on it and have replaced the transmission, radiator, & water pump. The tranmission hasn't operated as it should since the rebuild by Mr. Transmission, the water temperature hasn't been what it should (both from reading the gauge and inside heater temperature) since replacing oem rad with an aftermarket one, oil pressure switch was replaced as low or flucutating oil pressure was observed, and now the largest and most annoying problem of all has been determining the problem of stalling, rough running backfiring hard starting, intermittent starting, being more than likely due to a faulty crankshaft position sensor. Replaced with a used one from wreking yard didn't last more than a couple of hours and died. Guess it'll be worth spending a few extra dollars on a new oem replacement and see if it last a bit longer? Other than that it has been a good and enjoyable truck. Replies to this message: dustyk (Apr 26, 2009 9:57 am)
#59 of 68 Re: 1992 5.2 engine problems [moparlover3] by dustyk Apr 26, 2009 (9:57 am)
Replying to: moparlover3 (Apr 25, 2009 6:36 pm) You've provide three good examples of why I almost never deal in used parts.   Crankshaft Position Sensors were of irratic quality in your vintage Mopar motor. Fortunately, after the initial replacements you don't hear of too many failing a second time.   Still see a number of old Daks on the road. There are two of your vintage in my neighborhood, both have over 180,000 miles on them. A little rusty in spots, but looking a heck of a lot better than any eight-year-old S10!!   Best regards, Dusty
#60 of 68 General Info: Symptoms of Defective Throttle Position Sensor (TPS) on Do by dustyk Apr 26, 2009 (10:02 am)
The following list of symptoms associated with defective Throttle Position Sensors (TPS) on Dodge trucks are a compilation of actual field experiences, both observed and reported:   off-idle hesitation hesitation at speed rough engine idle intermittent rough engine idle rough idle then stalls engine RPM fluctuates at idle engine RPM flairs after start, then stalls engine stalls when placed into any gear engine stalls after start unless throttle pedal used engine stalls when throttle opened engine surges at speed engine performance poor: engine misfires under load/acelleration   irratic shifts irratic torque converter unlocking irratic or over sensitive 6-5 downshifts at speed (68RFE) irratic or over sensitive 5-4 downshifts at speed (545RFE) irratic or over sensitive 4-3 downshifts at speed (RE, RLE) 3-4 driveline clunk delayed 1-2 shift delayed 3-4 upshift 3-4 upshifts occurs abruptly after 2-3 shift no 3-4 upshift no 4-3 downshift no kickdown at speed no or irratic torque converter lock up no or irratic overdrive shift   Regards, Dusty
#61 of 68 Stalls on left turns by ravenp Jun 08, 2009 (3:16 pm)
I have a 2000 Dodge Dakota Sport with the V6 magnum, 3.9L and 4X4. The dealer replaced the engine just before I bought it. Both the vehicle and engine have about 89000 miles. Until recently I haven't had any problems with it. The issues that I'm starting to have are squealing belts and stalling. The belts, I replaced the tension pulley and the belt, but it still squeals. The stalling is the problem that worries me most. It only seems to happen, though, on slow left turns, whether the AC is running or not. It seems to idle right aroud 600-700 RPM. And after it stall, it's a pain to get restarted. Could these problems be linked?
#62 of 68 1990 Dodge Dakota 3.9 Automatic by 90dakotaguy Jul 25, 2009 (12:56 pm)
Hi all, I have a 1990 Dodge Dakota 3.9 V6 Automatic. I have an issue where after starting the truck and letting it run for about 15 minutes it stalls and will not start for about another 30-45 minutes. Now I've replaced everything that I thought it might be and still havent solved the problem. I've replaced the ECM, distributor cap and rotor, auto shutdown relay, fuel pump, fuel filter, coolant temp sensor, and I dont know where to go from here. Please anyone or maybe a mechanic, if you have any info on this I would greatly appreciate it because I'm seconds away from driving it into a lake! Thanks, Mike
#63 of 68 '05 Dakota stalls when engine cold by dodgewoes Aug 18, 2009 (11:28 am)
So, because I am dumb, I took my V8/auto tranny Dakota in to a dealer for it's first tune up and tranny service. The truck was running fine in all respects. I got back a mess. The tranny failed twice after getting the truck back, first the dealer blamed a bad new MOPAR tranny filter, the 2nd failure was a different bad tranny part (sorry can't find the paperwork). All this had the distinct feel of total BS coming from the dealer - as in I think the mechanic screwed up the tranny service royally, and they just wouldn't admit it.   Anyway - after the 2nd tranny failure, I got the truck back and it immediately began stalling shortly after morning start up - well within the first mile or so of driving, but only after the truck had been sitting a long while - like overnight.   Here are the exact symptoms.   Starts normally in the morning (I do not let the engine warm up - start and go, but I tried letting the engine come to temp before go doesn't have an impact on this problem). Drive to the first stop (uphill less than 1/4 mile away) as the truck comes to a full stop, the RPM's drop out and the truck stalls. Truck restarts immediately and does not stall again for the rest of the day.   Cold engine stalling is intermittent (roughly 50% of the time or less) in temps greater than 65 degrees, and almost always as temps dip below, with coldest winter temps causing multiple stalls, as opposed to just once in the morning, but again, will not continue to stall once warmed up). So the colder it gets, the more consistent and more frequent the cold engine stalling is until the engine warms up and then the engine will not stall for the rest of the day. I can prevent the stalling if I force the rpms to stay up by braking and tapping the gas simultaneously.   If I take a different route in the morning so I don't hit stop/go traffic while the engine is cold, I don't have a stalling problem (but it's a much longer route, and that's no solution)   Over the months, the dealer has had the truck back 5 times without success. They reset the computer on the first try, then replaced one of them (can't find the paperwork). Replaced the Oxygen sensor. Beat the engine with a hammer, had a Shaman do a pagan blessing, and then shrugged. I suggested the problem is tranny related because that's where all the troubles started, but the dealer says the tranny is fine.   Lawyers are expensive, and I just want my truck fixed.   Suggestions would be enormously appreciated. Replies to this message: 99_dakota (Sep 30, 2009 1:57 pm)
#64 of 68 Re: 95 5.2 Dakota just dyes [chip16] by hillbilly99 Sep 05, 2009 (10:39 am)
Replying to: chip16 (Apr 21, 2008 12:34 pm) Hey i am having the same problems..... I was wondering if maybe you came across the problem... Gsoybeanaol.com
#65 of 68 Re: 2000 Dodge Dakota 4x4 Quad Cab 4.7L magnum dying [paco161] by hillbilly99 Sep 05, 2009 (10:46 am)
Replying to: paco161 (Jul 23, 2008 1:11 pm) I have a 99 5.2 and its doing the same thing.....im in the same boat your are and i was wondering if that relay had anything to do with it....?? Gsoybeanaol.com thanks!

Messages Page 7 of 8 1 2 3 4 5 6 7 8 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Pickups Dodge Dakota Dodge Dakota Stalling and Dying Problems