Sign In Join 



Volkswagen Beetle Electrical & Lighting Problems

88 messages,  Last post on Sep 29, 2009 at 1:58 PM

You are in the Volkswagen Beetle Forum. Your Host is pf_flyer

What is this discussion about? Volkswagen New Beetle, Electrical, Oil


Messages Page 3 of 9
1
2
3
4
5
6
7
...
9
Prev
Next
Last
Go To Msg #
Search This Discussion

#19 of 88
Re: 2004 New Beetle battery removal and replacement [alanjack] by jasmith52
Jul 17, 2007 (10:06 am)
Reply

Replying to: alanjack (Jul 16, 2007 3:36 pm)

For the battery...
 
make sure that you disconnect the negative (black) lead on the batterty first.
 
Then when you hook up the car replace the negative (black) terminal last.
#20 of 88
EPC LIGHT by kaitross
Jul 31, 2007 (7:59 am)
Reply
question.....my EPC light came on, and in the manual it tells me to take it to a dealer asap, but what does this really mean? and how important is it to get looked at asap? thanks!!
#21 of 88
Re: Signal lights [sugarbear2] by jrieger
Aug 03, 2007 (10:19 am)
Reply

Replying to: sugarbear2 (Jul 16, 2007 11:41 am)

The hazard flasher controls your turn signal flashing. It pops right out of the control panel and should take a VW mechanic 10 minutes to replace. If you paid $85, you got scaaaaaaroooood.
#22 of 88
Re: Signal lights [jrieger] by sugarbear2
Aug 03, 2007 (2:05 pm)
Reply

Replying to: jrieger (Aug 03, 2007 10:19 am)

Thanks for the info but as I had said before they did tell me that it was the hazard light switch. And just a small note I didn't pay $85 to get "scaaaaarooooood". I had it checked while they were correcting the recall therefore, didn't pay $85.
#23 of 88
Re: Signal Lights not Working Help! [sugarbear2] by kaitross
Aug 14, 2007 (8:22 pm)
Reply

Replying to: sugarbear2 (Jun 23, 2007 7:10 am)

i took my husbands 97 jetta to get the turn signals, hazard lights, horn adn wipers fixed (NONE WORKED AT THIS POINT!!!)and they had to change the turning signal relay switch, about $100 and they were all fixed with that same part...could be it! not sure though......
#24 of 88
Window not working - A/C Cutch Problem - High Temp light by guns2
Aug 17, 2007 (11:51 am)
Reply

Replying to: kaitross (Jul 31, 2007 7:59 am)

Ok Guys here we go....
Have a 2000 beetle, this thing has been a nightmare. so far this is whats been going on over the past 3 weeks.
 
Week 1 - A/C comp only getting 8 volts, so now A/c doesnt work.
 
Week 2 - Drivers side power window quit working
 
Week 3 - now the high temp light goes on and off - even when cold???...
 
This car is driving me nuts, along with my wife harping at me all the time saying "when are you going to fix this". Problem is, I keep trying but cant get anywhere. The 8 volts on the Compressor I think might be a ground issue? The high temp light on/off might be a bad sensing device? and as far as the window not working-I havnt even got to looking at it. This car is starting to make my stomach hurt...
 
PLEASE HELP ME!!!
#25 of 88
Re: Window not working - A/C Cutch Problem - High Temp light [guns2] by jrieger
Aug 19, 2007 (11:59 am)
Reply

Replying to: guns2 (Aug 17, 2007 11:51 am)

The air cond. has a module that will control the compressor. It's in the engine area, below the battery.
 
The heat light is an easy one (I hope). Add some coolant to your coolant bottle. The contacts inside must be covered!
 
Can't help with the window but hope other info helps.
#26 of 88
Rear hatch sensor by madmax85
Aug 19, 2007 (12:59 pm)
Reply
I'm having a problem with my rear hatch icon staying on. Also, the same day that started, my car quit beeping when I woudl set the alarm. I know it must be a sensor problem but don't know where the rear hatch sensor is located or whether it is something I can repair. I'm out of warranty and I'd rather avoid the service department if at all possible. Can someone provide some insight?
#27 of 88
Reply by guns2
Aug 20, 2007 (3:43 am)
Reply
Thanks Jrieger
#28 of 88
VW Beetle, 2000 Electrical system failure by bill142
Sep 04, 2007 (5:07 am)
Reply
I have a 200 beetle. Here is what I have experienced without any warning:
 
Electrical system components stopped working:
Horn, Turn Signals, AC & Blower, Vent controls, Winshild wipers & Fluid controls, Head Lights.
 
Here are the electrical systems still operating correctly:
Radio, Brake Lights, Running Lights, Pwr Windows, Pwr locks, Pwr Moon roof, Pwr trunk, Pwr gas door release, Car starts and runs normal !
Pleaee Note - The hazard flashers work, the momentary bright lights when you pull back on the turn singal works.
 
I have verified all fuses next to the battery are OK, All fuses in the fuse box are OK, I have removed the covers to access the relay panel. I removed all relays and checked all relay coils with a VM and everything looks OK. There were no contacts welded.
 
No sure where to go from here. Any suggestions.

Messages Page 3 of 9
1
2
3
4
5
6
7
...
9
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics
Advertisement