You are here: Forums Pickups Dodge Ram Dodge Ram Idle and Stalling Problems

Dodge Ram Idle and Stalling Problems

149 messages,  Last post on Nov 29, 2009 at 5:12 PM

You are in the Dodge Ram Forum. Your Host is kcram

What is this discussion about? Dodge Ram Pickup 1500, Dodge Ram Pickup 3500, Dodge Ram Pickup 1500 SRT-10, Truck

Messages Page 15 of 16 1 ... 10 11 12 13 14 15 16 Prev Next Last

Go To Msg # Search This Discussion

#133 of 149 2003 dodge ram hemi by charliebrown77 Oct 07, 2009 (5:38 pm)
after refueling i can drive a little ways and the red electrical light flashes and the engine has very lil throttle response it acts like it has down shifted to just drive rpms about 2500 when it does this but i can pull over cut off the truck and it will crank rite back with no problem does anybody know what it can be and how much it will cost
#134 of 149 wtf by dale68 Oct 09, 2009 (9:06 pm)
installed a rebuilt 5.2lt in my 99' dodge 1500, got everything back together, did a pre fire inspection, everything looked good, went to fire it, no fuel pump. started to try and find problem and realized we weren't getting spark either. went through all electrical connections, confirmed they where all good. even cleaned all connections with contact cleaner, unhooked and sprayed all computer connections with contact cleaner. cap and rotor where replaced during this process. switched asd relay with other simular relay in pcm, no luck!! i wonder if the cps is at fault? how do you reset the asd? anybody have any suggestions?
#135 of 149 95 1500 360 stalling. by james1247 Oct 11, 2009 (3:26 pm)
replaced crank sensor for erratic rpms. replaced magnetic pickup due to stalling. will idle forfever in all gears. will back up fine. put it in drive and it stalls in 20-25 feet.wait a few minutes and it will start back up and stalls again.have new rotor ,cap,wires gapped the plugs ,tps(it broke off) and replaced both cam and crank sensors again and no change. i need help as i gotta have this truck running and soon. Replies to this message: dale68 (Oct 12, 2009 12:24 pm)
#136 of 149 Stall and rough idle Ram 1500 by will009 Oct 12, 2009 (11:22 am)
I was having trouble with this ,idle and stall when slow down , have a 2000 dodge 1500, 5.2 engine/ 318 v8 , , // spent $50 , , replacing this and that , , a certified mech on this form, , said unplug idle position sensor , , I did , , wouldn't idle at all , without foot on gas pedel , , ,but it caused engine light to come on , , , I disconnected neg bat terminal to reset computer , , , it turned engine light off and cured my idle and stall problem , , that was 3 days ago , , still runs fine , , no problem , , just though , I'd pass the infro on, , , plese note , , messing with vaccum is what caused the problem , in the beginning , , I believe , Dodge left a bug in the computer , and the engine light should have , already been on , , good luck
#137 of 149 Re: 95 1500 360 stalling. [james1247] by dale68 Oct 12, 2009 (12:24 pm)
Replying to: james1247 (Oct 11, 2009 3:26 pm) i read in my haynes manual that if your fuel filter is plugged, or partially plugged, you'll get enough fuel for the truck to run, and it will have enough pressure so the computer doesn't realize there's a problem, but you won't have enough volume to run the vehichle at driving speed. maybe try a fuel line cleaner or try idling it up for a extended period of time and see if it stalls. if it does maybe your filter is partially plugged. just a thought, good luck.
#138 of 149 Dodge ram 2006 by brylc2020 Oct 16, 2009 (11:36 am)
having problems with truck shutting down while driving. when this happens I have no power stering. any suggestions
#139 of 149 '09 5.7L engine stall and will not restart..... by krajicekdodge Nov 14, 2009 (7:05 am)
I have a Ram 1500 '09 5.7L that has stalled out while driving twice now and will not re start right after stalling, but after sitting for a while waiting for the tow truck, it will start. I have had it to a dealer when I was out of town and they could not find anything wrong because it started for them, but they did a software upgrade to a computer mod for better idle performance. Just stalled again last night, same issue. This time it I got it to re start once, then shut if off and it will not start again. Waiting for the dealer to call me this morning - 11/14/09. Anyone else had this trouble? Replies to this message: tistal (Nov 20, 2009 7:11 am) krajicekdodge (Nov 20, 2009 8:56 am) corkscrew (Nov 21, 2009 5:39 am)
#140 of 149 98 dodge ram 4+4 360 by matlock84 Nov 19, 2009 (3:21 pm)
when first started it runs fine then when it warms up it does not want to take off you have to give it a lot of gas to get it to take off any help please
#141 of 149 Re: '09 5.7L engine stall and will not restart..... [krajicekdodge] by tistal Nov 20, 2009 (7:11 am)
Replying to: krajicekdodge (Nov 14, 2009 7:05 am) I had the same problem. THe first time at 1200 miles, they said the fuses weren't seated correctly. The second time at 2700 miles, they said the PCM software needed to be updated. The service manager actually called me and said the truck starts and said there wasnt a problem before he updated the software. The third time it happened at 2750 miles (the very next time I drove the truck). They replaced the whole computer (PCM) module. I filed lemon law while it was in the dealership because it was a serious safety hazard. It turned off while driving down the street everytime. Noone at dodge would give me actual reasons or even tell me "Im sorry". I'm in mediation right now with chrysler. Replies to this message: krajicekdodge (Nov 20, 2009 8:56 am)
#142 of 149 Re: '09 5.7L engine stall and will not restart..... [tistal] by krajicekdodge Nov 20, 2009 (8:56 am)
Replying to: tistal (Nov 20, 2009 7:11 am) Thanks for the info. Same thing happened to me with the dealer. Was out of town when it first happened. No problem found, updated the PCM. Was going ok, then it happened again while I was back at home. At the local dealer, they found no problems or codes, but the did drive it and it happened to them, also no codes found. Then they started checking the fuel pump pressure and the electrical. Final result, they said at the fuel pump it had a loose connection that would disconnect with vibrations and that's why it wouldn't start. They dropped the fuel tank and replaced the pump and made sure all connections were solid. It drove from the dealer home with no problem, but have not had it out since.

Messages Page 15 of 16 1 ... 10 11 12 13 14 15 16 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Pickups Dodge Ram Dodge Ram Idle and Stalling Problems