You are here: Forums Pickups Dodge Ram Dodge Ram Idle and Stalling Problems

Dodge Ram Idle and Stalling Problems

138 messages,  Last post on Oct 16, 2009 at 11:36 AM

You are in the Dodge Ram Forum. Your Host is kcram

What is this discussion about? Dodge Ram Pickup 1500, Dodge Ram Pickup 3500, Dodge Ram Pickup 1500 SRT-10, Truck

Messages Page 14 of 14 1 ... 8 9 10 11 12 13 14 Prev Next Last

Go To Msg # Search This Discussion

#129 of 138 dodge ram dies while driving by birddog07 Sep 09, 2009 (8:20 pm)
This started out a few ago only stalling out when making turns a few times, engine stalls no breaks no engine lights no steering. put in neutral or park restarts no problem. No computer codes were brought up runs great starts but just stalls seemed like a fluke bad gas just put high to mid grade no help   Now a few months later engine has stalled at speeds 20-75 mph this time not turning just driving like before no brakes, steering, the radio & dash lights work will work fine while this happens put have to put in neutral or park starts up normal runs normal no hesitation or sluggishness just will die on while driving Im in florida the weather is warm its happen on cools days and days you could boil an egg in!   It did it again today crazy thing I had 2 kids in truck doing 50 engine cut out had no control over truck since no breaks and no steering when this happens almost hit a sign and a car?   No luck with dealer here as showing no issues and of course doesnt do it when they drive it but this is a truck my wife drives and she is very scared to drive it now and dont blame he much after my experience any one whom could help with answer?
#130 of 138 Stalling and missing but cannot find problem by jjwalke1 Sep 17, 2009 (3:07 pm)
i am having a problem with my 95 dodge ram stalling when i backup and start forward and let off the gas. It is also missing in overdrive at approx. 1200 rpms. I have replaced the fuel pump, indexed the timing, new plugs, wires, and distributer cap, new map sensor, new O2 sensor, new throttle body position sensor, and cleaned all fuel injectors. I thought the exhaust might be backing up and disconnected it and drove it around. I also have sprayed ether looking for a vacuum leak. I am at wits end as is my dad(mechanic) and 2 other shops. Its been hooked up to computers and wont even throw up a code. Any ideas out there as to what is wrong. Could it be a computer problem or maybe the transmission. Replies to this message: corkscrew (Sep 18, 2009 3:34 am)
#131 of 138 Re: Stalling and missing but cannot find problem [jjwalke1] by corkscrew Sep 18, 2009 (3:34 am)
Replying to: jjwalke1 (Sep 17, 2009 3:07 pm) Check battery voltage. With the engine running, you should get 14volts +/- 0.2V at the battery terminals.A battery that is 3 years old or older should be suspected as the PCM is very sensitive to low battery voltage even when the engine starts normally.   Another possibility is the auto shutdown relay circuit. Although I would expect to see a fault code 42 in this case. Corkscrew
#132 of 138 Re: engine surges at stops and rough idle [randy2931] by bigrun50 Oct 05, 2009 (7:23 am)
Replying to: randy2931 (May 10, 2009 11:01 pm) It's most likely your IAC. I had the same problem on my 2003 Dodge RamVan 5.2L. I thought it might be the fuel pump, glad I researched a bit and saved myself around 250 dollars. You should be able to buy an IAC for around 43 dollars at most auto parts stores. The van kept stalling at red lights or when I took my foot off the gas pedal, it got progressively worse. Heres a link on the web that helped me out. http://www.justanswer.com/questions/1qcde-1998-dodge-ram-stalls-unless
#133 of 138 2003 dodge ram hemi by charliebrown77 Oct 07, 2009 (5:38 pm)
after refueling i can drive a little ways and the red electrical light flashes and the engine has very lil throttle response it acts like it has down shifted to just drive rpms about 2500 when it does this but i can pull over cut off the truck and it will crank rite back with no problem does anybody know what it can be and how much it will cost
#134 of 138 wtf by dale68 Oct 09, 2009 (9:06 pm)
installed a rebuilt 5.2lt in my 99' dodge 1500, got everything back together, did a pre fire inspection, everything looked good, went to fire it, no fuel pump. started to try and find problem and realized we weren't getting spark either. went through all electrical connections, confirmed they where all good. even cleaned all connections with contact cleaner, unhooked and sprayed all computer connections with contact cleaner. cap and rotor where replaced during this process. switched asd relay with other simular relay in pcm, no luck!! i wonder if the cps is at fault? how do you reset the asd? anybody have any suggestions?
#135 of 138 95 1500 360 stalling. by james1247 Oct 11, 2009 (3:26 pm)
replaced crank sensor for erratic rpms. replaced magnetic pickup due to stalling. will idle forfever in all gears. will back up fine. put it in drive and it stalls in 20-25 feet.wait a few minutes and it will start back up and stalls again.have new rotor ,cap,wires gapped the plugs ,tps(it broke off) and replaced both cam and crank sensors again and no change. i need help as i gotta have this truck running and soon. Replies to this message: dale68 (Oct 12, 2009 12:24 pm)
#136 of 138 Stall and rough idle Ram 1500 by will009 Oct 12, 2009 (11:22 am)
I was having trouble with this ,idle and stall when slow down , have a 2000 dodge 1500, 5.2 engine/ 318 v8 , , // spent $50 , , replacing this and that , , a certified mech on this form, , said unplug idle position sensor , , I did , , wouldn't idle at all , without foot on gas pedel , , ,but it caused engine light to come on , , , I disconnected neg bat terminal to reset computer , , , it turned engine light off and cured my idle and stall problem , , that was 3 days ago , , still runs fine , , no problem , , just though , I'd pass the infro on, , , plese note , , messing with vaccum is what caused the problem , in the beginning , , I believe , Dodge left a bug in the computer , and the engine light should have , already been on , , good luck
#137 of 138 Re: 95 1500 360 stalling. [james1247] by dale68 Oct 12, 2009 (12:24 pm)
Replying to: james1247 (Oct 11, 2009 3:26 pm) i read in my haynes manual that if your fuel filter is plugged, or partially plugged, you'll get enough fuel for the truck to run, and it will have enough pressure so the computer doesn't realize there's a problem, but you won't have enough volume to run the vehichle at driving speed. maybe try a fuel line cleaner or try idling it up for a extended period of time and see if it stalls. if it does maybe your filter is partially plugged. just a thought, good luck.
#138 of 138 Dodge ram 2006 by brylc2020 Oct 16, 2009 (11:36 am)
having problems with truck shutting down while driving. when this happens I have no power stering. any suggestions

Messages Page 14 of 14 1 ... 8 9 10 11 12 13 14 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Pickups Dodge Ram Dodge Ram Idle and Stalling Problems