Last post on Apr 16, 2013 at 4:54 PM
You are in the Dodge Sprinter
What is this discussion about?
Dodge Sprinter, Engine, Van
#45 of 85 engine oil filter location
Mar 02, 2008 (10:09 am)
I have a Winnebago View Motorhome on a 2007 sprinter 2500 with the mercedes v-6 turbo diesel chassis. Can someone tell me where the locations of the engine oil filter and oil drain plug are on this unit.
#46 of 85 Tire Rotation
Mar 02, 2008 (6:07 pm)
">I would like to know the reason why you are not allowed to change the direction of the tire rotation. The owner manual on page 196 say the rotation should not be reversed. Why? ">
#47 of 85 Glow Plug Diagnoses
Mar 04, 2008 (1:57 pm)
I have a problem with my glow plug light staying on in the dash. Is there a way to check my glow plugs with an ohms meter at the plug of the contoller? If so what type of reading should I expect?
#48 of 85 Re: engine oil filter location [ososlick]
Mar 07, 2008 (9:56 am)
I have the I-5, but would guess that the drain plug is low on the pan on the driver's side. Many would say that the more efficient way to change oil is to suck it out of the dipstick tube and leave the drain plug alone. Easy if you have a vacuum source, a simple tool and a proper container.
Mercedes uses a cartridge filter mounted high on the engine, usually on the driver side as well. Look for a black cap, point straight up that looks a bit like the bottom of a canister-type oil filter... use a matching filter wrench "cup"... all seals on this unit are "o"-rings and must be replaced every time you change oil (they come in the filter box). lube the o-rings and install by hand only, then gently tighten (the o-rings seal, the torque-down does not enhance the seal... so don't over-tighten).
#49 of 85 Re: Sprinter Maintenance [kurt6]
Jul 23, 2008 (2:29 pm)
Where would I find a maintinance manual for 2005 mercedes sprinter van. Please send your answer to Thank you.
Jul 23, 2008 (6:32 pm)
I purchased a service manual for my 2006 sprinter directly from Chrysler publications.
The only drawback I saw is that it was only available on CD, not book form.
Maybe even check ebay
Aug 27, 2008 (10:40 am)
I am finally going to put new brakes on my 04 Sprinter cargo van. I have the 140" wheel base with 16" tires 2500SCH. It is the first set of brakes and I have 60,000 mi. on them. Needless to say they are metal to metal. The problem I have is finding pads and rotors for this van. NAPA wants to know if I have the Bosch calipers. It turns out I do have Bosch calipers, took the front tire off to find out,hope the rear is the same. Now they want to know what size rotor I have. Apparently there are three different sizes listed in millimeters. How can I tell what size the rotor is? Are there any special concerns I should watch for when I finally get all my brake parts together? By the way I love this vehicle. Only two minor recalls that I am aware of and no major problems. They do need to learn how to paint this vehicle properly. And why after 4 yrs. can't I find a repair manual for this vehicle? By the way, I purchased my van from Fyda Freightliner in Columbus, Ohio and they have been very courteous and fair and timely with the recalls and scheduled maintenance I had them do while the vehicle was under warranty. After warranty I started doing my own scheduled maintenance. You do not have to go to Dodge or Chrysler dealer if there is a Freightliner dealer selling Sprinters near where you live.
#52 of 85 Re: New Brakes [luvmysprinter]
Aug 27, 2008 (12:37 pm)
Usually I get my parts from egermanparts.com. They now carry some maintenance parts like filters. I just checked for your brake parts to no avail.
Some other sites to check are stopshopanddrive.com and the links from that website.
Does the Freightliner dealer sell these parts? These sprinters have been around forever in other countries; maybe there is a parts source in Canada.
Regarding the shop manual, I found a CDRom factory manual from chrysler publications, but it is not as straightforward as having a paper manual.
Oct 18, 2008 (2:27 pm)
Does anyone know where to find the axle codes on a
#54 of 85 Re: Glow plugs,glow plug module [codenamecuckoo]
Dec 15, 2008 (6:06 pm)
Had similar problem on 04 bought used. Dealership wanted outrageous price to replace glow plugs, module, and injectors. Did not allow work as van drove very well untill cutting out suddenly. Usually running fine after restart, other times having to wait 15 minutes to an hour to run. Don't see how glow plug problems could ever cause a stopping problem once the engine is running. Finally took to second dealership as loosing power too. They quickly found a short in the wiring harness which was probably causing the error messages. After picking up and driving home, the engine light came back on. Found out the egr valve was bad I would guess as a result of my continuing to run with the wiring problem. After replacing it myself, the van has run very well, am extremely pleased. Only other problem since has been the negative battery cable. Connections very clean, cable looked new but high resistance and warm after trying to start so you may check that as well.