Isuzu Trooper Engine Misfire

38 messages,  Last post on Aug 14, 2011 at 9:57 AM

You are in the Isuzu Trooper Forum.

What is this discussion about? Isuzu Trooper, Isuzu Trooper II, Electrical, Engine, Exhaust, SUV

#37 of 38 Re: left bank head not firing. [lemon19] by catfuzz

Aug 11, 2011 (6:52 pm)

Replying to: lemon19 (Aug 10, 2011 4:38 pm)
You have timed the engine wrong. If you followed a Haynes or Chilton manual, this is the result. They don't have the correct procedure for these engines. Tear it back down, line up the crank mark with the mark on the oil pump. Now, locate the timing mark on the passenger side head. Turn the cam and it will thunk thunk into certain spots. Keep thunking it around until the mark on the sprocket naturally lines up with the mark on the head. It may take several turns. Then go the drivers side. There are TWO marks on the head for this one. One that is in a similar location to the passenger side and another one about 90 degrees to the LEFT. Thunk, thunk the cam until it naturally lines up with the second mark mentioned. Now, turn the sprocket to the right 90 degrees to line it up with the top mark. It may not want to stay there. Install your belt with the marks on the belt lining up with the timing marks and hold it in place with some clips. reset your tensioner and install. You can install the lower crank pulley temporarily and start the engine to confirm you got it right.

#38 of 38 Re: left bank head not firing. [catfuzz] by lemon19

Aug 14, 2011 (9:57 am)

Replying to: catfuzz (Aug 11, 2011 6:52 pm)
Catfuzz your the greatest. You are a pro... Next time they should let you write the book.. Thanks for your help. I did tried it 3 times and it didn't work. My friends thought I was crazy bout only one side of the head working. Again thanks.
To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement