Last post on Jul 08, 2010 at 1:03 PM
You are in the Ford F-Series
What is this discussion about?
Ford F-250, Ford F-350, Electrical, Truck
#3 of 12 97 to 99 engine swap
Apr 15, 2007 (11:44 am)
Hello all. Is there anyone that can tell me if I can put a 4.6L engine from a 97 F150 4x4 into a 99 4x4. I belive the heads are different. Engine mounts and tranny should be the same. Anybody know conclusivley if this is possible or not?
Thanks in advance for your help.
Jun 10, 2007 (11:04 am)
i have a 1991 f250 with 5.8L windsor engine, manual tranny.
what motors can i swap into this shell?
#5 of 12 Bad starter relay?
Jun 10, 2007 (11:09 am)
have a 1991 f250, it starts most times after a long sit.
sometimes it won't crank at all, no dash lights on nor headlights. is this the starter solenoid?
also, it runs well but occasionally its like the tranny gets too hot and won't shift into 1st gear (manual tranny).
After it sits for a few hours (cools off) it runs fine if it starts. Is this a clutch problem or is it related to starting issues?
#6 of 12 engine swap
Oct 17, 2007 (8:16 am)
i have a 1992 f150 whith 5.0 engine i swap to 4.6 iam loking for the wiring diagram to start the 4.6 engine
#7 of 12 02 v10 in a 99
Jun 30, 2008 (11:50 pm)
Does anyone know abut this setup. I have a chance for a great deal on a 2002 v10 400 miles on it. and my 99 has 180k. think it might need a freshin up but way less work with newer motor. Any help and/or ideas are helpful
#8 of 12 no headlights and won't crank
Jul 13, 2009 (6:38 pm)
Has anyone come across this before? Battery has a full charge, and all other electrical seems to work. But it won't crank, and headlights are out.
I just swapped out dist cap, rotor, and plug wires-could I have damaged a circuit?
Thanks for any information.
#9 of 12 1992 ford f250 460 cui swap
Jul 18, 2009 (10:36 am)
I have a 1992 ford f250 4X4 460cui would like to go to a much smaller engine. can i? whats involved?
Jul 20, 2009 (4:37 pm)
I am new to this media. So far I read questions including my own, but no answers. Where are the answers posted?
#11 of 12 Re: answers [brokenford]
by KCRam@Edmunds HOST
Jul 22, 2009 (5:47 am)
If someone has the answer to your question, they'll post it here. Unfortunately, not all questions get a response; it may simply mean that no one here knows the answer.
kcram - Pickups/Wagons Host
#12 of 12 Engine swap options?
Jul 08, 2010 (1:03 pm)
I have a '73 f250 with a tired 360 and a C6 A/T. I want to swap engines, but don't want to have to make modifications. I've been looking at a 351M, but was told I'd have to change motor mounts, bell housing, and exhaust. What are my options?