Sign In Join 



Chevy S10 - GMC S15 and Sonoma Starting problems

195 messages,  Last post on Nov 20, 2009 at 8:21 AM

You are in the Chevrolet S-10 & GMC S15 Sonoma Forum. Your Host is kcram

What is this discussion about? Chevrolet S-10, GMC S-15, GMC Sonoma, Engine, Truck


Messages Page 17 of 20
1
...
14
15
16
17
18
19
20
Prev
Next
Last
Go To Msg #
Search This Discussion

#159 of 195
Re: electrical problem on 1995 s-10 sonoma [bullseye1] by gonogo
Jan 10, 2009 (7:42 am)
Reply

Replying to: bullseye1 (Jan 10, 2009 7:00 am)

Check connections for battery. At the battery, at the starter and the battery ground to engine.
#160 of 195
1986 Gmc S-15 2.8l WILL NOT START, HELP!!!! by metric1
Jan 12, 2009 (8:22 am)
Reply
86 Gmc s-15 2.8l 6 cyl 4x4
 
Hi everyone, any help you could offer would be more than greatly appreciated. I bought this truck over a month ago, so i am not super framiler with it yet, anyway it drove fine for the first 3 weeks of coarse, then one morning i went to the truck drove about 8 blocks could heard some squelling(which would happen for 20-30sec when truck started) the truck started to kick/jump as if it was running outta fuel, i put the accelerator down to keep it from stalling out, pulled over, it idled fine looked under the hood, nothing obviously out of the ordinary got back in when i tried to change from 1st to second again i lost power and had to hammer down the accelrator trying to get home drove sorta normal for about 8 blocks heading back, then started dying again and finally stalled out a block from home. After that could not start truck at all, engine just turns with no start, not even any kicking or combustion. Had a weak spark so replaced the wires coil, disct cap and rotor and plugs, so i have good spark to all 6 cylinders tested out good, there is fuel coming out of the tbi unit, i can hear the fuel pump start and i replaced the pump relay to make sure that was not of issue, i have not been able to start car with starting fluid or pouring gas in...running outta ideas here...if you have a suspesion or something i should check please let me know! Thanks alot!
-Chris
#161 of 195
car wont start by gvestal
Feb 13, 2009 (2:14 pm)
Reply
try to start car then a quick flame shoots up from where the fuel injectors are and flames dies out
#162 of 195
car wont start by gvestal
Feb 13, 2009 (3:27 pm)
Reply
almost forgot,1991,s-10,blazer,4.3
#163 of 195
1999 Chevy S10 engine swap by fran4066
Feb 15, 2009 (2:33 pm)
Reply
Does any one know if one can swap a 4.5 V6 from a 2005 Malibu into a 1999 Chevy S10 with a 4.3 V6, what would be the changes that need to be made, if any.
Thank you for your help
#164 of 195
Re: 1999 Chevy S10 engine swap [fran4066] by CDII
Feb 20, 2009 (12:06 am)
Reply

Replying to: fran4066 (Feb 15, 2009 2:33 pm)

I am no expert, but I am sure you cant. I think front wheel drive motors turn oppisite direction than a rear wheel drive motor. Also just for info, look up 3.4 camaro engine swap. Hope this helps.
#165 of 195
will not start by olehambone
Mar 06, 2009 (6:46 am)
Reply
I have a 94 gmc sonoma, v6, manual trans. about 200,000miles. Great truck. A couple weeks ago when starting it would be real slow like the battery was getting weak. Now when I turn the key I get nothing, no click or nothing. Lights work etc. service engine light comes on. So I took battery out and had it checked. It was ok.
Someone said it had to be alternator. I replace alternator, still nothing, no sound or click. Now someone said it must be starter. Where is the starter on this truck and I thought if it was the starter I should hear a clicking sound? What do you think?
#166 of 195
starting issue w/99 gmc sonoma by jayoebee
Aug 25, 2009 (7:12 pm)
Reply
I have a 99 sonoma w/4.3 h.o. It was cranking and finally would catch after 2-3 attempts. I cleaned out the iac motor and the ports and intake sensors. It'll start right up for the first few attempts then it will just crank and not catch at all. Once it is started and running it will start up immediately but if it sits overnite it wont start at all. Any input would be greatly appreciated
#167 of 195
will not start after accedent by caloke
Aug 26, 2009 (2:06 pm)
Reply
i have a 1986 chevy s10 blazer and it was in a small accedent when it was brought home it was running normal then just shut off and now will not start, has no fire, that injetor are not spraying but they have power to them, and the svc engine light dose not come on at all,can not get any code from the ECM its like its not there, have checked; fuel pump(ok), battery(ok), timimng(ok), change ECM from another running truck(no change in problom)
#168 of 195
Re: will not start after accedent [caloke] by gonogo
Aug 27, 2009 (7:23 am)
Reply

Replying to: caloke (Aug 26, 2009 2:06 pm)

Sounds like no power to the ecm, did you check the fuses. Should be an ECM B and ECM 1. Not that familiar with a 86, it does sound like a power problem, short maybe.

Messages Page 17 of 20
1
...
14
15
16
17
18
19
20
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement