94 messages,
Last post on Jan 31, 2013 at 1:59 PM
You are in the
Chevrolet S-10 & GMC S15 Sonoma Forum.
What is this discussion about?
Chevrolet S-10, Auto Repair, Truck
#91 of 94 Re: O2 Sensor Heater [wjs4]
by bill0054
Oct 24, 2011 (5:05 am)
have the same truck shop had it for 2 weeks replaced both sensors and the converter, came back on after 40 miles.
#92 of 94 2001 S-10 ABS module replacement
by barrow944
Nov 02, 2011 (8:26 am)
My 2001 S-10 crew cab has the abs lights on in the cab. The dealer said the code indicated low voltage going to the abs module. Any ideas if this is a wiring issue or a bad module. I am going to try to check the voltage if I can get the probes to the terminal. For replacing the module, a local junk yard has one from a 2000 S-10 Blazer and I would like to know if this will work? Its appearance is different although the interface with the valve it is mounted on looks the same. Looking for some help. Thanks
Nov 20, 2011 (9:12 am)
have a 2002 chevy s-10 pickup.. 4.3l 4 wheel drive,,auto 110.00 miles got the code p0101 last week. TRUCK WAS LOOSING POWER BIG TIME AND PINGIN WHEN GOIN UP HILLS WHEN THROTTLE WAS PRESSED MORE THAN HALFWAY... GOT BEST GAS AND TREATMENT..STLL NO HELP.... put another map and maf sensor in.. no luck.. put a new fuel filter in light went out but it still s not running right... my cat was bad so replaced it.. engine light went off and truck seemed to run better.. still alittle pingin in engine.. well light caME ON AGAIN TODAY... NOT SURE WHAT ELSE IS BAD.. GOIN TO SEE WHAT CODE IT IS 2DAY.. CHECKED VACUUM LINE FOR LEAKS ALSO..
#94 of 94 Cranks no start
by n2tile
Jan 31, 2013 (1:59 pm)
Cranks no start i have spark & fuel stopped at store went to leave Cranks no start out of the blue been running fine but the service engine light came on 4 day earlier could it be the MAF sensors?