Last post on Jan 31, 2013 at 1:59 PM
You are in the Chevrolet S-10 & GMC S15 Sonoma
What is this discussion about?
Chevrolet S-10, Auto Repair, Truck
#88 of 94 SES light stays on
Jun 07, 2011 (7:16 pm)
Hello, I am having a problem with my 02 S10. A couple of months ago the Service Engine Soon light came on and I brought it to the shop. They found it to be P0410 (airpump malfunction). They replaced the airpump. About a week later the light came back on. I brought it back. They told me it was a loose gas cap, cleared the code and sent me on my way. A week later, light on. Brought it back, they tested it all out, including the routing of the hoses going to the airpump. They replaced the air pump and solenoid because they could find nothing else wrong (they did find a TSB on it and did everything the TSB directed). A week later, light came back on. Brought it back, they replaced air pump and solenoid again. BTW, each time the code has read the same. They threw in a free oil change for my trouble. About 5 days later, light came on again. I have not gone back. It's been on for about a week. Has anyone else had any similar issues? Any ideas of why the light keeps coming on? Thanks.
#89 of 94 1999 s-10 2.2 truck with a miss in cylinder number 2
Oct 20, 2011 (5:10 pm)
i have a 1999 chevrolet s-10 2.2 pickup i have a miss in it i had it scannned it said it was cylinder number 2 i replaced plugs and wires with no change when it is cold it runs ok the more i drive the worse it gets
#90 of 94 Re: 1999 s-10 2.2 truck with a miss in cylinder number 2 [bingham1]
Oct 21, 2011 (8:22 am)
Have it checked for intake leak.
#91 of 94 Re: O2 Sensor Heater [wjs4]
Oct 24, 2011 (5:05 am)
have the same truck shop had it for 2 weeks replaced both sensors and the converter, came back on after 40 miles.
#92 of 94 2001 S-10 ABS module replacement
Nov 02, 2011 (8:26 am)
My 2001 S-10 crew cab has the abs lights on in the cab. The dealer said the code indicated low voltage going to the abs module. Any ideas if this is a wiring issue or a bad module. I am going to try to check the voltage if I can get the probes to the terminal. For replacing the module, a local junk yard has one from a 2000 S-10 Blazer and I would like to know if this will work? Its appearance is different although the interface with the valve it is mounted on looks the same. Looking for some help. Thanks
Nov 20, 2011 (9:12 am)
have a 2002 chevy s-10 pickup.. 4.3l 4 wheel drive,,auto 110.00 miles got the code p0101 last week. TRUCK WAS LOOSING POWER BIG TIME AND PINGIN WHEN GOIN UP HILLS WHEN THROTTLE WAS PRESSED MORE THAN HALFWAY... GOT BEST GAS AND TREATMENT..STLL NO HELP.... put another map and maf sensor in.. no luck.. put a new fuel filter in light went out but it still s not running right... my cat was bad so replaced it.. engine light went off and truck seemed to run better.. still alittle pingin in engine.. well light caME ON AGAIN TODAY... NOT SURE WHAT ELSE IS BAD.. GOIN TO SEE WHAT CODE IT IS 2DAY.. CHECKED VACUUM LINE FOR LEAKS ALSO..
#94 of 94 Cranks no start
Jan 31, 2013 (1:59 pm)
Cranks no start i have spark & fuel stopped at store went to leave Cranks no start out of the blue been running fine but the service engine light came on 4 day earlier could it be the MAF sensors?