You are here: Forums Pickups Chevrolet S-10 & GMC S15 Sonoma Chevy S10 - GMC S15 and Sonoma Warning lights and trouble codes

Chevy S10 - GMC S15 and Sonoma Warning lights and trouble codes

76 messages,  Last post on Nov 10, 2009 at 12:39 PM

You are in the Chevrolet S-10 & GMC S15 Sonoma Forum. Your Host is kcram

What is this discussion about? Chevrolet S-10, Auto Repair, Truck

Messages Page 7 of 8 1 2 3 4 5 6 7 8 Prev Next Last

Go To Msg # Search This Discussion

#56 of 76 Sonoma 2000 by darcy4 Jun 04, 2008 (9:25 am)
#57 of 76 Sonoma 2000 by darcy4 Jun 04, 2008 (9:25 am)
2000 Sonoma extended cab v6 engine   MY check engine lights AND ABS lights Brake lights are coming Have all new brakes and tires put on not long ago so know this is not the problem Took to dealer and they said they fixed it also over driving for a while it shifts hard into first gear   3 weeks later it is happen again any fix suggestion Thanks
#58 of 76 check engine light 97 gmc sonoma by wannarace Jun 18, 2008 (9:27 pm)
check engine light on again came up cyl 6 misfire I changes plugs reset engin light 2 dats later check engine light on again comes up cyl 6 misfire again any thoughts?
#59 of 76 Where is this sensor located? by rcrick0 Jun 09, 2008 (10:37 am)
#60 of 76 Where is this sensor located? by rcrick0 Jun 08, 2008 (6:38 pm)
hello i have a 2000 chevy s-10 v-6 engine light came on for while and went off , then came back on , now the truck wont start , i ran the problem code its the evaportive emission system pressure sensor/ switch, so where is the located , i looked in the repair book but doesnt show it or nothing   thanks Rick D. Replies to this message: gonogo (Jun 09, 2008 10:37 am)
#61 of 76 Re: Where is this sensor located? [rcrick0] by gonogo Jun 09, 2008 (10:37 am)
Replying to: rcrick0 (Jun 08, 2008 6:38 pm) It usually means the gas cap is leaking, but it won't stop it from starting.
#62 of 76 ENGINE CODES by tituscanby Sep 13, 2008 (3:38 pm)
I KEEP GETTING CODES 24 AND 34.I HAVE REPLACED BOTH AND CLEARED THE CODES BY REMOVING THE BATTERY CABLES AND THEY STILL KEEP SHOWING UP.THIS IS ON A 1986 S10
#63 of 76 OBDll error by tnyodm Oct 08, 2008 (12:38 pm)
I've tried to scan my 95 S-10 with 3 scanners but they all give an error reading. No blown fuses. Any suggestions? Thanks, Tony.
#64 of 76 94 chevy S-10 2.2 5spd. CODE 41 ??? by jonny300000 Nov 14, 2008 (3:00 pm)
truck runs perfect... check engine on, cleared the code. comes on, right when started up every time? the definition is.. no ignition (1X) reference pulses. what does that mean?? what do i need to check? anyhelp would be great. thanks john. like i said the truck starts and runs perfect...
#65 of 76 98 s10 all dash warning lights flash on and off by steve203 May 21, 2009 (4:24 am)
While driving, usually at low speed all of my warning lights flash on at the same time for 2-3 seconds, the speedo goes to 0 then back to speed indicated, fuel gauge and temp gauge do the same. Motor never skips a beat. Truck has 66,000 miles. Any thoughts? Replies to this message: steve203 (Jul 07, 2009 3:08 pm)

Messages Page 7 of 8 1 2 3 4 5 6 7 8 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Pickups Chevrolet S-10 & GMC S15 Sonoma Chevy S10 - GMC S15 and Sonoma Warning lights and trouble codes