Ask the Car People.SM


Chevy S10 - GMC S15 and Sonoma Warning lights and trouble codes

94 messages,  Last post on Jan 31, 2013 at 1:59 PM

You are in the Chevrolet S-10 & GMC S15 Sonoma Forum.

What is this discussion about? Chevrolet S-10, Auto Repair, Truck

Messages Page 10 of 10

#85 of 94 brake warning light flashing by mike550

Jan 02, 2011 (5:42 pm)

My brake warning light has been on for awhile. I've not paid much attention to it. But now its flashing 3 short 1 long flash repeatedly. like ( . . . - . . . - . . . - ) I keep a good eye on my fluid level and its still good. All my lights are working. Does anyone know what this means? It's a 91 Chevy S-10....2.5

#87 of 94 Sonoma 99 by jesskallie

Jan 26, 2011 (4:23 pm)

I was taking the truck back to work yesterday it started fishtailing almost and started kind of popping. I got it back into the driveway but the brakes have just gone out. I can floor the brakes and barely stop at all. Pumping them at least gets it to stop but it isn't drive-able. It's the middle of a Michigan winter so its not under great conditions, I'm not sure if maybe the drums are frozen or if i have a leak in my break lines or if the fluid is just low. Any ideas? If its my fluid how can I check it

#88 of 94 SES light stays on by girlcat

Jun 07, 2011 (7:16 pm)

Hello, I am having a problem with my 02 S10. A couple of months ago the Service Engine Soon light came on and I brought it to the shop. They found it to be P0410 (airpump malfunction). They replaced the airpump. About a week later the light came back on. I brought it back. They told me it was a loose gas cap, cleared the code and sent me on my way. A week later, light on. Brought it back, they tested it all out, including the routing of the hoses going to the airpump. They replaced the air pump and solenoid because they could find nothing else wrong (they did find a TSB on it and did everything the TSB directed). A week later, light came back on. Brought it back, they replaced air pump and solenoid again. BTW, each time the code has read the same. They threw in a free oil change for my trouble. About 5 days later, light came on again. I have not gone back. It's been on for about a week. Has anyone else had any similar issues? Any ideas of why the light keeps coming on? Thanks.
 

#89 of 94 1999 s-10 2.2 truck with a miss in cylinder number 2 by bingham1

Oct 20, 2011 (5:10 pm)

i have a 1999 chevrolet s-10 2.2 pickup i have a miss in it i had it scannned it said it was cylinder number 2 i replaced plugs and wires with no change when it is cold it runs ok the more i drive the worse it gets

#90 of 94 Re: 1999 s-10 2.2 truck with a miss in cylinder number 2 [bingham1] by gonogo

Oct 21, 2011 (8:22 am)

Replying to: bingham1 (Oct 20, 2011 5:10 pm)
Have it checked for intake leak.

#91 of 94 Re: O2 Sensor Heater [wjs4] by bill0054

Oct 24, 2011 (5:05 am)

Replying to: wjs4 (Nov 19, 2010 7:44 pm)
have the same truck shop had it for 2 weeks replaced both sensors and the converter, came back on after 40 miles.

#92 of 94 2001 S-10 ABS module replacement by barrow944

Nov 02, 2011 (8:26 am)

My 2001 S-10 crew cab has the abs lights on in the cab. The dealer said the code indicated low voltage going to the abs module. Any ideas if this is a wiring issue or a bad module. I am going to try to check the voltage if I can get the probes to the terminal. For replacing the module, a local junk yard has one from a 2000 S-10 Blazer and I would like to know if this will work? Its appearance is different although the interface with the valve it is mounted on looks the same. Looking for some help. Thanks

#93 of 94 2002 chevy s-10 by chaney6366

Nov 20, 2011 (9:12 am)

have a 2002 chevy s-10 pickup.. 4.3l 4 wheel drive,,auto 110.00 miles got the code p0101 last week. TRUCK WAS LOOSING POWER BIG TIME AND PINGIN WHEN GOIN UP HILLS WHEN THROTTLE WAS PRESSED MORE THAN HALFWAY... GOT BEST GAS AND TREATMENT..STLL NO HELP.... put another map and maf sensor in.. no luck.. put a new fuel filter in light went out but it still s not running right... my cat was bad so replaced it.. engine light went off and truck seemed to run better.. still alittle pingin in engine.. well light caME ON AGAIN TODAY... NOT SURE WHAT ELSE IS BAD.. GOIN TO SEE WHAT CODE IT IS 2DAY.. CHECKED VACUUM LINE FOR LEAKS ALSO..

#94 of 94 Cranks no start by n2tile

Jan 31, 2013 (1:59 pm)

Cranks no start i have spark & fuel stopped at store went to leave Cranks no start out of the blue been running fine but the service engine light came on 4 day earlier could it be the MAF sensors?

Messages Page 10 of 10

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement