Sign In Join 



Taurus/Sable Transmission Problems

120 messages,  Last post on Oct 28, 2009 at 4:49 AM

You are in the Ford Taurus/Mercury Sable Forum. Your Hosts are pat & karens

What is this discussion about? Ford Taurus, Mercury Sable, Transmission, Sedan, Wagon


Messages Page 8 of 12
1
...
5
6
7
8
9
10
11
12
Prev
Next
Last
Go To Msg #
Search This Discussion

#71 of 120
96 taurus transmission by mratajczak
Apr 21, 2008 (4:47 pm)
Reply
computer says shift selenoid problem. car wont shift into 4th gear. or could this be a range sensor? where are they located?
#72 of 120
2001 taurus by leej56
Apr 23, 2008 (3:51 pm)
Reply
how do you replace the sway bar links
#73 of 120
Re: 96 taurus transmission [mratajczak] by fordfan_17
Apr 24, 2008 (9:03 am)
Reply

Replying to: mratajczak (Apr 21, 2008 4:47 pm)

shift solenoids are located in the side pan of the transmission.removal of this side pan dang near requires complete removal of the trans. but it can be done in the car.if the range sensor is bad the pcm would have returned a mlps code of some sort
#74 of 120
1994 tranny by skinnyguy
Apr 29, 2008 (12:30 pm)
Reply
i have a 1994 tauras, the tranny will shift into all gears some days and others it will only hit 2nd gear. i have changed the filter and fluid but still no change. can any one help?
#75 of 120
Re: 1994 tranny [skinnyguy] by fordfan_17
May 01, 2008 (8:16 am)
Reply

Replying to: skinnyguy (Apr 29, 2008 12:30 pm)

take your car to a local tranny shop that does free roadtests and diagnosis have them pull the history codes and freeze frames but it sounds to me like a sensor flaking out like a manual lever position sensor. which if you get repaired immediately should not result in any major repairs.
#76 of 120
1995 Taurus Transmission by jerryparks
May 25, 2008 (6:27 pm)
Reply
My '95 Taurus Trans will not shift into lst gear easily when I start out. After
    rev up the motor, it will finally engage. But after I stop, I have to start over
  with the same procedure. It shiftsfine in all other gears. I've changed the
   fluid and filter. Car only has 99k miles and motor runs excellent.
#77 of 120
Re: 1995 Taurus Transmission [jerryparks] by fordfan_17
May 27, 2008 (8:53 am)
Reply

Replying to: jerryparks (May 25, 2008 6:27 pm)

axode transmissions in the earlier years had an aluminum forward clutch piston that would crack and give the concern you are describing normally the forward piston will be cracked or the wave spring in the drum broken to pieces and is stacked up under the forward clutch and is binding the forward clutch apply ...either way im sorry to say it sound like its time for an o/h
#78 of 120
Re: 2000 mercury sable tranny problem [djcriple420] by orcharddude
May 27, 2008 (9:08 pm)
Reply

Replying to: djcriple420 (Jan 22, 2008 9:52 pm)

I have a 2000 mercury sable ls, vulcan engine w/ 124k on original powertrain and I am experiencing similar problems to the previous post by djcriple420. I have had fairly regular flushes, and just changed the filter on the tranny just recently, although the shifting has improved significantly, it still shifts harder than it should like it's extending the shift from 1st to 2nd and 2nd to 3rd and then shifting somewhat harder into gear. I am not rough on the car, and performed all regular maintanence. It pulls no codes when hooked to a scanner. I would like to get another 40k-50k out of the car, do you have any recommendation on what this could be? Any similar experiences? Do i need a rebuild? Any advice would be appreciated, thanks.
#79 of 120
Re: 2000 mercury sable tranny problem [orcharddude] by fordfan_17
May 28, 2008 (11:25 am)
Reply

Replying to: orcharddude (May 27, 2008 9:08 pm)

harsh shifts in this unit can be related to worn out valves in the valve body normally with every overhaul i install new boost valve and sleeve and also converter bypass valve since these valve cycle a bunch they wear down and leak by the valves. this can be done without removing the trans from the car as what is called a valve body service it still consists of a lot of work for trans shop 2-3 hrs labor at least but possibly can avoid major overhaul if you get the valves fixed
 
look at www.sonnax.com your trans id will be AX4S/AXODE/AX4N
you will find a number of replacement valves listed for your transmission there
#80 of 120
1996 ford by muncy
May 31, 2008 (9:02 am)
Reply
i have a 1996 ford taurus with a bad transmission i have a spare one out of a 1999 taurus only diff i see is the little grey box on the gear shift control can i change that box to work with my spare

Messages Page 8 of 12
1
...
5
6
7
8
9
10
11
12
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement