17 messages,
Last post on Jun 22, 2009 at 8:10 AM
You are in the
Chevrolet Cavalier Forum.
What is this discussion about?
Chevrolet Cavalier
#12 of 17 Rattles and noises
by lburgess
May 19, 2008 (2:19 am)
Had the mechanic replace the right side wheel bearing assembly. $132.00. Noise gone
#13 of 17 Re: Cavalier w/ humming noise (not bearing) [tifflynn83]
by corvettefan427
Jun 14, 2008 (9:00 pm)
based n how you described it there is nothing wrong when the thunking noise happens. There's a technical service bulletin on this car describing this exact situation, and it's nothing that is wrong with the car. For the humming, it may just be gear whine if you have a manual, mine does it too.
#14 of 17 Wheel bearings gone for the third time in two years
by richonect
Sep 23, 2008 (10:08 pm)
I have replaced my wheel bearings (front) three time now in two years. I am getting ready to replace them again because I keep getting the same vibration that goes away when I change them out. I am wondering what would cause them to be going bad so quickly? I sthere any other problems I need to be looking into?
#15 of 17 front left squeals when i turn left or when i tape the brake
by bobcooper20
May 12, 2009 (7:42 am)
i have had my bearings replaced once on the front left and lately when i turn left it makes a squealing noise plus when i first start to brake it squeals then stop also my steering wheel does not jerk or its not hard to turn left any thoughts ?
#16 of 17 Re: Wheel bearings gone for the third time in two years [richonect]
by steven0420
May 27, 2009 (6:44 am)
There is a rubber seal that goes around the bearing and is easliy damaged when replacing the bearing. Therefore the bearing runs good for a year or two but then salt, sand, tiny rocks, etc. find their way back into the bearing and begin to wear it down again. Hope this helps
#17 of 17 1998 Rattling Noise serpentine Area
by rorytate
Jun 22, 2009 (8:10 am)
Hi,
I've just recently discover a rattling noise coming from the serpentine belt area. I don't think it's the alternator. It makes the noise in P and in Drive. If it is one of the wheels in the serpentine, how much am I looking to pay to have it fix/replaced?
On a scale of 1-10 (1 being easiest) how hard would it be to do myself. I do have the shop manual.
Thanks!
Matt