Sign In Join 



Acura Integra Engine Questions

98 messages,  Last post on Aug 04, 2009 at 9:24 AM

You are in the Acura Integra Forum. Your Host is pf_flyer

What is this discussion about? Acura Integra, Engine, Hatchback


Messages Page 7 of 10
1
...
4
5
6
7
8
9
10
Prev
Next
Last
Go To Msg #
Search This Discussion

#60 of 98
Question about heating problem by kxiong87
Jul 16, 2008 (3:06 pm)
Reply
I currently own a 91 Acura Integra LS. I've been having overheating problems. So some people suggest I change the thermostat so I did and the problem still occurs. My radiator is still in an ok condition. I tested driving my car out to work and drove back home, my heating gauge started to climb pass normal heat which would be a little less than 50% of the gauge. I turned on the heat drove back home and realize there was some antifreeze dripping below my driver side tire. Anyone have any suggestion or tips etc... that I can deal with this problem?
#61 of 98
Re: What the hell is that sound [wolftheenf4cer] by tpark
Jul 17, 2008 (7:15 am)
Reply

Replying to: wolftheenf4cer (Dec 04, 2007 11:05 pm)

Where is the noise coming from?
#62 of 98
ENGINE SWAP HELP by tsb123
Jul 18, 2008 (12:02 pm)
Reply
Hi, I have a 2000 acura integra GS I want to place a and b16 a engine in it or SIR engine will it fit my car? And how much am I looking at for money wise?
#63 of 98
Re: Question about heating problem [kxiong87] by addtothehustle
Jul 21, 2008 (4:38 pm)
Reply

Replying to: kxiong87 (Jul 16, 2008 3:06 pm)

Check all your hoses for cracks and leaks. Best thing to do is pressure test it, you may have a small crack in the radiator, but it could be a head gasket too. numerous possibilities. Have you changed your timing belt and water pump?
 
Hope it helps, good luck
 
-addtothehustle
link title
#64 of 98
Am I getting screwed?? by addtothehustle
Jul 21, 2008 (4:52 pm)
Reply
I went to a mechanic regarding a noise in my front right tire. I thought it was the brakes but the mechanic says it can be any wheel bearing, all should be changed as well as a recommendation for replacing shocks. I know i don't need new shocks because i have a full tein suspension i got less than a year ago.. I need help, I can't afford to get screwed.
 
thanks
 
-addtothehustle
www.ineedaradiator.com
#65 of 98
Re: Am I getting screwed?? [addtothehustle] by tpark
Jul 22, 2008 (8:56 am)
Reply

Replying to: addtothehustle (Jul 21, 2008 4:52 pm)

I recently replaced my CV Halfshaft on the passenger side, which is the housing for the wheel bearing, and that cost me about $240. I have a 1990 Integra LS. That should be all that needs to be done in regards to the noise, which should sound like a popping or grinding. You are looking at around $250 to $300 dollars depending on where you go
#66 of 98
need help with my engine problem by 91rs
Jul 24, 2008 (8:48 am)
Reply
ok so i have a 91 rs integra with a b18a1 in it and for some reason when i take off in low rpms the car will sputter till about 3500 or so rpms or even if i punch it full throttle it will just sputter out and like barely gain any speed some people say i need to check my air flow sensors others say my injectors are going bad and some even say it may just be a bad spark plug so please help!!!!! i have no idea what is wrong with it
#67 of 98
exhaust smoke by jimbob1975
Aug 01, 2008 (9:56 pm)
Reply
Recently my 98 Integra LS (see post #58) began smoking upon acceleration under a load ( e.g. pulling away from a light). It does not appear to do so either at idle or at a steady speed, nor is the inside of the tailpipe oily; but it does have a lot of soot in it. Would I be looking at a major repair and if so; given the car's age and mileage, should I get the repair done even if it means getting a new engine?
#68 of 98
Timing? by hornzrul83
Aug 19, 2008 (7:18 pm)
Reply
Hi. I Own A 95 Integra LS that i just actually finished working on and finally got running. Well sort of running. I really need help to figure out what is wrong with my car now. The car idles to low and kinda rough. But when i drive it and as long as im giving the car gas or if its in gear it drives fine. But heres my problem. When i go to shift and push in the clutch, my rpms drop down to almost zero and the car wants to die. I have to give the car gas just to keep the rpms up and for the car not to die. Eventually though i cant catch them and the needle drops to zero and the car dies. If anyone knows or has any solution to my problem. I would appreciate all the help. Thx.
#69 of 98
blown timing belt by reefer007
Aug 21, 2008 (10:49 am)
Reply
I have a 91 2 dr integra that I have blown the timing belt on I have the valve cover off and am in the process of changing it but I want to know if I have caused any catastrophic damage to my engine. Also how do I check the valves and the pistins for damage . And if damaged is the motor junk and I would be better off just finding another engine to put in it or can the head be rebuilt? thanks

Messages Page 7 of 10
1
...
4
5
6
7
8
9
10
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement