You are here: Forums Coupes & Convertibles Chevrolet Camaro Chevy Camaro Maintenance and Repair

Chevy Camaro Maintenance and Repair

45 messages,  Last post on Nov 05, 2009 at 12:57 PM

You are in the Chevrolet Camaro Forum. Your Host is claires

What is this discussion about? Chevrolet Camaro

Share questions and tips on doing your own repairs and maintenance on your Camaro.

Messages Page 2 of 5 1 2 3 4 5 Prev Next Last

Go To Msg # Search This Discussion

#6 of 45 Re: 94 Camaro Replacement Parts [camaro94] by jayharold Nov 15, 2007 (7:41 am)
Replying to: camaro94 (Jul 27, 2007 8:10 am) Look at www.gmparts4less.com good luck
#7 of 45 Re: question about sanding and priming a camaro [bekynfrkme] by cynicalz28 Jan 11, 2008 (12:58 am)
Replying to: bekynfrkme (May 09, 2007 10:15 am) depending on what parts need to be fixed it would save u alot of problems down the road to get replacement pnaels because bondo is a temporary fix but it is not somthing u wanna rely on all the time
#8 of 45 High-beam switch broken by numbersguy Mar 13, 2008 (12:45 pm)
A couple owners back, my '86 IROC was apperently stolen. The thief had busted open the steering column to get to the ignition. However, because of this the switch to turn on the high beams cannot function. (I'm assuming the high-beams are turned on by pulling back the turning signal arm).   What exactly is that piece called? I could probably order a replace ment cover/case/column if I just knew the technical name for it. Replies to this message: okko1 (Mar 13, 2008 2:56 pm)
#9 of 45 Re: High-beam switch broken [numbersguy] by okko1 Mar 13, 2008 (2:56 pm)
Replying to: numbersguy (Mar 13, 2008 12:45 pm) dimmer switch
#10 of 45 chevy camaro engine problems by ghost329 Mar 30, 2008 (3:50 pm)
Hi i have an 84 camaro t- top. When I turn the vehicle on and press the exceleration it will rev up all the way and than begin to die off. I have to keep pressing the exceleration to keep it running.   I've changed out the spark plugs and fuel filter but it hasn't helped.   Anyone have any ideas
#11 of 45 Loose Steering Column on my 90 RS by outlawfox13 Mar 31, 2008 (9:35 am)
Well I am super happy that my wife got me a camaro for my birthday, it is a 90 RS 305 with T-tops and a 5 speed. And I can fix most every thing wrong with it but I have never come across this issue before. The steering wheel is loose, it travels up and down about an inch ( only the wheel, and not left to right ). I read up on it a bit but I am not sure if tightening the 4 bolts after the tilt will fix it or not. Anyone have this problem before?
#12 of 45 98 camaro with a v6 by gsxrguy2008 Jul 14, 2008 (8:17 am)
Hey everyone i have a 98 camaro with the v6 in it. the car was running great ive had it for 4 months now. the other day i was driving home i was only a mile from my house i got to my street and my car jus shut off... i pushed it on my block and i thought the fuel pump went out.. i left it there all day and came to check on it about 8 hours later and it started right up? i drove it straight home about 4 blocks and parked it fer the weekend. yesterday morning again it started right up so i let it run while i took a shower came out and it was off and wouldnt start again? does anyone have any idea why it might do this? Replies to this message: ls14evers (Feb 13, 2009 6:55 pm)
#13 of 45 91 RS flasher by kath202000 Jul 26, 2008 (8:58 pm)
where is the flasher for the turn signals located - or is there one?                      Thanks,                            Kathy Replies to this message: Mr_Shiftright (Jul 27, 2008 1:38 pm) ls14evers (Feb 13, 2009 6:51 pm)
#14 of 45 Re: 91 RS flasher [kath202000] by Mr_Shiftright HOST Jul 27, 2008 (1:38 pm)
Replying to: kath202000 (Jul 26, 2008 8:58 pm) The fuse panel is located behind the left hand side of the instrument panel. The hazard warning flasher is located behind the instrument panel to the right of the steering column, in the convenience center. The turn signal flasher on 1989 models is located behind the instrument panel, clipped to the right hand side of the steering column bracket. On 1990-92 models, the turn signal flasher is located behind the left hand side of the instrument panel, clipped to the fuse block bracket.   Visiting Host
#15 of 45 help w/ my 383 stroker!!! by pintoz Sep 03, 2008 (8:01 am)
I have a 91 iroc that has a 383 stroker, i need a tranny for her b/c 2nd is goin out! any ideas or anything? Replies to this message: Mr_Shiftright (Sep 03, 2008 8:34 am)

Messages Page 2 of 5 1 2 3 4 5 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Coupes & Convertibles Chevrolet Camaro Chevy Camaro Maintenance and Repair