You are here:
Forums
SUVs
Jeep Wrangler
Jeep Wrangler Transmission Trouble

164 messages, Last post on Oct 30, 2009 at 6:42 AM
You are in the Jeep Wrangler Forum. Your Hosts are steve_ & tidester
|
I just purchased an '03 Saraha, 5-speed, 6 cyl.. I drives great, no jumping out of gear, shifts smooth however, it sometimes (about 50% of the time), sounds as though the throw-out bearing is going out. When I 'm stopped and engage the clutch the noise quits. Throw-out bearing, right? I had two very good mechanics who both had similar jeeps, look and listen to it. Naturally, it didn't make a sound. They both told me that my year(s) and model jeep are notorious for tranny noise and not to worry too much about it. Back in 1991 I owned a brand new GMC with a 5-speed standard tranny with almost identical sound problems...the GMC mechanic told me this: It's an aluminum transmission box that resonates sound more than cast iron, the gears have much closer tolerances than the old transmissions and because needle bearings are used, automatic transmission fluid takes the place of 80-90 all purpose. Thus more noise will be heard. He cured the problem by draining a pint of auto trans fluid and added some "Morley's" stabilizer. Has anyone heard of doing this with the Jeep transmission or adding a Lucas or some other brand stabilizer? |
|
|
This morning when I started to back up the jeep, it wouldn’t move as if the brakes were on! Checked the emergency brake, it was off. Set it on and off to be sure. Still won’t move. Won’t go forward or backwards. In neutral, I cannot move it even by pushing it by hand. I tried shifting to 4wd, same. Put transmission in N, same. Won’t move. I jacked up the rear tires and they won’t move and they should. The front tire will rotate. I used the vehicle about a week ago and it ran fine and shifted fine. The 4wd and 4wd low also worked fine. I simply drove it into the garage and turned it off. Now it won’t budge. Details: 1991 Jeep Wrangler, 174k miles. Runs fine, no serious leaks, shifts fine, engine is strong. Can’t get it to a shop unless I flat bed it. Expense!! Thoughts? Ideas on how to unlock the transmission so I can get it to a shop? Thanks for any suggestions.
|
|
| Do I have the tranny rebuilt or replaced? I am ready to purchase a master rebuild kit from quadratec and have the work done at my local shop but I want to make sure that this is the right move. Replies welcome | |
|
Replying to: snellen (Aug 07, 2009 6:53 am) While it may be the transmission or the transfer case, it could also be the differential. To establish which it is, disconnect the rear driveshaft. If it then rolls easily it's a transmission problem, if it's still locked up it's the rear axle causing the problem. |
|
what year jeep hard top's will fit a 2005 wrangler
|
|
|
Replying to: grizzly6 (Sep 27, 2009 12:02 pm) |
|
|
|
|
Replying to: nomad443 (Dec 29, 2008 8:11 am) |
|
|
|
| i have a 97 wrangler sport 5 speed and my 5th gear doesn't hold speeds compared to my brothers 97 wranger sahara 5 .speed. My brothers jeep holds 80 easy were mine can hold 65 when i am lucky but usual only 60. has anyone had this problem. I have a cold air intake and a throttle body spacer. Resently had to replace o2 sensor in back of the cat. talk with some people and they said the rattling i had some time back might have been the cat breaking apart which might block the exhaust flow but i would think that would effect all gears not just 5th. | |
You are here:
Forums
SUVs
Jeep Wrangler
Jeep Wrangler Transmission Trouble
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Jeep Wrangler



Browse by Board
Browse by Topic
Today's Chats