Last post on Aug 06, 2013 at 7:13 AM
You are in the Toyota Tacoma
What is this discussion about?
Toyota Tacoma, Brakes, Truck
#92 of 117 2001 Toyota Tacoma, weird noise
Aug 17, 2010 (10:38 am)
I recently purchased a 2001 Toyota Tacoma 4x4 SR5 with 100000, V6. It is an excellent driving pick-up, I am very happy with it. I have recently noticed when I stop and I take my foot off of the break, I get a weird bump sensation, it does not do it all the time, and I notice it more prominently if I break hard, and take my foot off of the break. It shifts nice, no audible noise from the transmission, no wheelbearing problems. Shifts in and our of gear nice, by the way it is an automatic, no clunking, does not do it in gear while driving, only when I'm stopped taking my foot off the break to drive while in gear.
#93 of 117 Shimmy in 2011 Tocoma
Sep 09, 2010 (12:31 pm)
I just picked up a 2011 Tacoma 4 cylinder on 9-6-2010. I noticed between 60 & 65 mph a very slight shimmy. The truck does not appear to be out of alignment. Only 225 miles on it. I plan on tacking it back to the dealer to check it out. Has anyone had a similar experience and what to expect from the dealer?
#94 of 117 Re: 2001 Toyota Tacoma, weird noise [ruger20gauge]
Sep 15, 2010 (11:47 am)
Ruger, My 2005 Tacoma 2x4 SR5 Double cab does the EXACT same thing. Did you figure out the problem?? Anyone else on here have any idea?
#95 of 117 Re: New Tacoma driveline vibration! [sergeante6]
Oct 24, 2010 (2:07 pm)
I have a 2006 TRD 4X4 Double Cab that I bought used from a Toyota dealer as a "Certified Preowned." I noticed a slight shimmy around 5-10 MPH in forward or reverse. I assumed it was the tires and eventually (about 1.5years) replaced them. Surprise! The shimmy is still there. I took it into the dealer and the Toyota extended warranty refused to fix it because it was lifted. (it was that way when I bought it "Certified" with warranty) The dealer has been trying to fix it for almost 8 weeks now and can't figure it out. At this point they are just shot gun replacing parts. Here's what they've done so far..... Replaced the center bearing, replaced the drive shaft, replaced the rear transmission mounts, replaced the rear leaf springs, tried a different rear-end, removed the lift and put factory tires on it.
None of that has resolved the issue. Only one thing resolved the issue. Removing the rear drive shaft and driving it on the front drive. And in some sort of, well I don't know, they have decided to obtain a lift kit with an angle to adjust the drive line angle to factory. (despite it still having the issue when the brought it to factory height with factory tires)
I have been telling them that I think it is the transfer or transmission, but they are refusing to look at it at this point.
No, I am not a mechanic, and no I did not stay at a Holiday Inn Express, but I think that the transfer and/or transmission should be looked at.
Anybody have any ideas or wisdom? Any good lawyers want to take this on? LOL
8 weeks in the shop is a bit excessive, especially because the loaner they give is a Corolla, which an 8ft ladder doesn't quite fit in.
#96 of 117 2010 Tacoma Shimmy
Dec 23, 2010 (8:56 pm)
I have the shimmy/vibration problem noted in other posts on a new 2010 Tacoma. The problem didn't start until the truck had about 15,000 miles on it. The vibration happens at speeds above 25. Dealer tried alignment and balancing and the truck drives straight but the vibration is still there and it feels like the truck is fighting itself. With all the posts on this site, anyone tried sharing these with a dealer to get a response?
#97 of 117 Re: New Tacoma driveline vibration! [b_olsen]
Dec 23, 2010 (10:02 pm)
#98 of 117 Re: 2010 Tacoma Shimmy [rtm68]
Dec 24, 2010 (8:46 am)
My 2006 was in Bell Road Toyota in Phoenix Arizona working on my shimmy for over 9 weeks. They have given up on it. I got fed up and traded it in on a 2010 Ford F150 Raptor. Interestingly enough, I figured out the problem with mine while taking it to trade it in. The shimmy mine had disappeared when I put it into 4 high. The dealer said "it sounds like the transfer is bad." Funny thing, I told them I thought it was the transmission or transfer when I brought it in. It just took them 2 months and replacing everything but the trans/transfer/engine.
Good luck with yours.
#99 of 117 Re: 2010 Tacoma Shimmy
Dec 24, 2010 (9:02 am)
The shimmy has plagued the Tacomas since when they were introduced in 2005. They know about it. Its more pronounced depending on the type of road you drive on. I have a 2005 Dual Cab Prerunner. Why Toyota doesn't address the problem is beyond me. Maybe complaints to the government are in order. Maybe they don't want any more black eyes in the media. Ah well, great truck otherwise....I really hate the fact that they don't step up to the plate and acknowledge the problem and make it right.
#100 of 117 Re: New Tacoma driveline vibration! [okie147]
Jan 08, 2011 (11:27 am)
I have a 97 taco 4X4 (manual hubs), manual tranny 2.7 liter and I experience a front end shudder/vibration...only in neutral (with the clutch released) when I'm coasting. If I push in the clutch or put it into any gear the vibration stops. I have checked all the fluids, ball joints, tie rods, axles, etc and cannot find any answers. I have brand new tires and have had them balanced and aligned multiple times...to no avail. I was hoping you would have some insight since we have both owned the same truck. I would appreciate a response if you have time, I know your post was a long time ago but any help would be greatly appreciated.
#101 of 117 Re: Vibration noise under hood [rko9869]
Feb 01, 2011 (3:53 pm)
HI everyone, i have a 07 double cab with the same problem. It is the plastic part that goes into the fender well, i replaced the foam insulation on it, so it is tight to the fender. This worked for awhile now the noise comes and goes but is very bad at time, i am still trying to figure on what to do next. As in replacing the part along with the flexible hose with the k&n filter system as i saw on one site but i can not remember which one. Thanks and hope this helps.