Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
Sedans Saturn ION Saturn Ion Starting Problems
363 messages, Last post on Nov 16, 2009 at 2:01 PM
You are in the Saturn ION Forum. Your Hosts are pat & karens
| hi,thank you guys for the recomendations on cuting the white wire but I have a question,can I cut the wire while the car is off ,because it wont start after I replaced the ignition switch..does anyone has the same experience?thank you all... | |
|
|
|
Replying to: fbordoy (Jan 05, 2009 6:52 am) You cannot cut the wire when the car is off. Apparently that screws it up. as for starting your car. Did you do the relearn procedure for the car? also, I was using a hair dryer on my ignition to get it started in the cold. |
|
|
Replying to: bertbaggins (Jan 05, 2009 8:00 am) Cutting the white wire while the car is running, making sure not to short the wires out, is all that needs to be done? Yes or No Thank you very much.
|
|
|
|
|
Replying to: Notrag (Jan 06, 2009 10:07 am) |
|
|
Replying to: bertbaggins (Jan 05, 2009 8:00 am) 
|
|
|
Hello all, I had a few questions: 1. Is the white wire part of the ignition switch? 2. I read in earlier posts that a possible problem might be with the type of "lube" in the ignition switch. The coined "northern climate" vs "southern climate" lube. Does that idea relate at all to the cutting of the white wire. 3. Does anybody know of any remote car starters for manual transmissions that are easy to install? I know from the sounds of it that the remote starter spoken of on this blog seems to be easy to install for automatic transmissions. My wife has a standard, and we were quoted about $250 to have a remote starter for a manual transmission installed. 4. How long will a new ignition switch last before the starting problems begin again. Thanks, Cold and Frustrated Husband
|
|
|
|
|
Replying to: dave7878 (Jan 06, 2009 8:27 pm) 2. As far as the lube thing, I don't really know. One guy tried it, and it worked, but some people have had no luck with it. I would't recomend doing anything with it. 3.I'm not sure how to install a manual starter. I do have a bypass switch that I tried to figure out, but I needed a remote starter in order for it to work. I thought I could hook up the bypass without a remote starter, but that turned out to not work. 4. Don't change the ignition switch. everyone on this board that did that ended up buying another one like a year later. Some people have bought several of them. It's just throwing money down the drain. Cut the wire while the car is running and be done with it. That seems to work the best for everyone |
|
|
|
|
Replying to: fbordoy (Jan 06, 2009 5:24 pm) |
|
|
Replying to: bertbaggins (Jan 07, 2009 7:09 am) 1. Would it be possible to some how insulate the wire so it doesn't get cold? 2. As far as I read earlier, it seemed that the wire is a thin wire and as a result doens't transmit a proper signal when cold. Would it be possible to replace that wire with a thicker guaged wire? Thanks, Cold and Frustrated Husband
|
|
|
|
|
Replying to: dave7878 (Jan 07, 2009 3:47 pm)
|
|
You are here:
Forums
Sedans Saturn ION Saturn Ion Starting Problems
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2007 Saturn ION
Browse by Board
Browse by Topic
