You are here: Forums Pickups Ford Ranger Ford Ranger 4x4 Problems

Ford Ranger 4x4 Problems

62 messages,  Last post on Aug 11, 2008 at 12:38 PM

You are in the Ford Ranger Forum. Your Host is kcram

What is this discussion about? Ford Ranger, Truck

Messages Page 7 of 7 1 2 3 4 5 6 7 Prev Next Last

Go To Msg # Search This Discussion

#58 of 62 Re: 97 Ranger 4WD problem [russpatz] by twalden Apr 23, 2008 (7:34 pm)
Replying to: russpatz (Feb 27, 2008 12:34 pm) i have a 95 and it does the same thing. the auto locking hubs suck.
#59 of 62 Auto locking hubs by copperranger Jun 02, 2008 (11:22 am)
2000 ford ranger 3.0 flex engine my front hubs wont connect. when i shift into 4X4 high or 4X4 low you can feel the the transfer case hooking up but the front wheels wont pull. anybody have any ideas about what could be wrong Replies to this message: cessna180 (Jun 02, 2008 6:18 pm)
#60 of 62 Re: Auto locking hubs [copperranger] by cessna180 Jun 02, 2008 (6:18 pm)
Replying to: copperranger (Jun 02, 2008 11:22 am) i have a 98 ranger, its a vaccum, system, and ive had similiar problems, if the system, gets gunked up, [actually the fork, wont engage]... from eithier lack of use,.. or,..bad vaccum, [aka hose,] ive found and spoken with ford dealers ,... this sounds crazy but, smack the housing with a rubber mallet, or take the unit apart and clean it,... obviously bad design, the key ive heard... switch to manual locking hubs, or use it once a month,.. id like any more feedback, on this as well.. sincerely cessna 180.
#61 of 62 Broken u-joint yoke by jbreshears Jun 19, 2008 (7:22 pm)
Hello, I've acquired a nice '87 Ranger 4x4 with 4 cyl, 4 speed and manual hubs, for crawling through the woods. I have broken the left front u-joint yoke when the joint went out. The axle side yoke is ok. Can anyone tell me the steps to disassemble that part to replace the broken yoke? Must I pull the axle to install the u-joint. It looks like it might be done in place. I appreciate the help. j
#62 of 62 Re: my 1998 3.0 manual, is stuck in 4x4low [cessna180] by ncherry Aug 11, 2008 (12:38 pm)
Replying to: cessna180 (Mar 12, 2007 6:19 pm) I just bought a 2000 Ford Ranger 4X4. When I turned the drive switch to 4WD High the light came on, but when I turned the switch to Low the High light stayed on. Checked fuse #28 and found it was missing. It was the only empty slot with contacts in the bottom. Installed a fuse and now the High and Low lights work. Not sure, but believe the 4WD is working...doesn't seem to skid when in a hard turn on soft ground. In any case, thanks for the tip. Does anyone have any idea why someone would remove the fuse? Regards, Norm

Messages Page 7 of 7 1 2 3 4 5 6 7 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Pickups Ford Ranger Ford Ranger 4x4 Problems