Ask the Car People.SM


Toyota Sienna Electrical Problems

102 messages,  Last post on Feb 11, 2013 at 3:59 PM

You are in the Toyota Sienna Forum.

What is this discussion about? Toyota Sienna, Electrical, Lights, Van

Messages Page 6 of 11

#51 of 102 Re: Radio Display blank [hershg] by tomd8

Jul 03, 2009 (6:27 pm)

Replying to: hershg (Jul 18, 2008 8:11 am)
I have the same problem with my radio. It will display when turn on and then no display later but radio is still working. I have to turn off the radio then turn back on to get the display again. I was wondering did you fix your problem. Thanks.

#52 of 102 Re: Radio Display blank [tomd8] by hershg

Jul 06, 2009 (6:50 am)

Replying to: tomd8 (Jul 03, 2009 6:27 pm)
No, but, this sounds crazy, rapping your knuckles on the display when the radio gets into a bad state seems to "fix" it.

#53 of 102 Re: 01 Sienna dash light issue [livnrileysmom] by toyotagts

Sep 12, 2009 (7:00 pm)

Replying to: livnrileysmom (Apr 19, 2009 9:13 am)
It sounds like you need to replace the light bulbs in the dash. It is not that hard. There are about 3 screws that you have to take out, one to the left of the steering, look up, and 2 over by the radio, in which you have to pull the plastic off there. Then the rest of the dash pops out. Then you will remove 4 screws to the display. The light bulbs that light the display are the large green screws like fixtures. The bulbs are haligens that pull out of the fixtures. There are 4 bulbs total for this area. The Air flow area is a bit more tricky. You have to remove the screws for control area, the dash will already be out of your way if you do both at the same time. There are 3 bulbs, smaller, in this area. The little push button switches have their own bulbs that you have to purchase at the dealer. The other bulbs you can buy at any auto parts store and at wal mart. Let me know if you have any trouble with this and I will be glad to help.

#55 of 102 Inside lights don't come on when door opened- not fuse by ukmomma

Oct 19, 2009 (1:40 pm)

My 2005 Sienna's inside lights stopped working in the van- except the front ones - but none work any longer when doors open.
Husband tried fuse - it is ok.
Any other ideas?

#56 of 102 Tail lights blowing fuse on Toyota Sienna 98 by lovemysienna2

Dec 31, 2009 (8:17 am)

All other lights work. The 10 amp fuse under the steering wheel blows immediately when I put in a new fuse.
 
Any advice on what to look for or change?

#57 of 102 Re: Tail lights blowing fuse on Toyota Sienna 98 [lovemysienna2] by ateixeira

Jan 02, 2010 (7:52 am)

Replying to: lovemysienna2 (Dec 31, 2009 8:17 am)
There must be a short in the wiring that goes to that light.
 
Take it (the taillight) out and clean it up, see if there's any dampness there. Check the bulb itself as well.
 
I'm far from an electrical expert but I had a radio that kept doing that, and the solution was to replace the radio.

#58 of 102 2001 Sienna Amp by ccity1

Jan 03, 2010 (8:29 am)

My front speakers blew out a few months ago... It wasn't a volume issue, they just slowly - and seperately - chose to go... I had them replaced, and soon after my radio decided to work sometimes and then cut out (although the display stays on as if it is working fine).
 
But now I can't get any sound at all (though still the same situation with the display) ... The radio 1 and 2 fuses behind the ashtray are fine... could the amp be blown?

#59 of 102 Re: 2001 Sienna Amp [ccity1] by wwest

Jan 03, 2010 (10:49 am)

Replying to: ccity1 (Jan 03, 2010 8:29 am)
That might mean you had DC, Direct Current, flowing through the speakers as the amp was in the process of failing.

#60 of 102 2008 Toyota Sienna Radio Volume Issue by druzilla1977

Aug 21, 2010 (7:06 am)

So over the past year or so, my wife and I have noticed a problem with the radio volume. Occasionally, the volume will increase on its own and can not be turned down using the knob on the radio itself. You must use the volume control on the steering wheel. The dealership can not duplicate the problem and says that they've checked all the wiring and it seems to be hooked up correctly. I've talked to others in the waiting room at the dealership with the same issue and results. Any suggestions on how to go about fixing this problem?

Messages Page 6 of 11

To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement