Last post on Nov 26, 2011 at 6:41 PM
You are in the Ford Ranger
What is this discussion about?
Ford Ranger, Ford, Truck
#16 of 30 ford ranger dash and cab
Jun 29, 2008 (3:12 pm)
i am trying to take the dash out of my 1999 ford ranger and im having problems with the wires. ive unhooked them all over the place and still cant get them all out without cutting them is there an easier way of doing it with having to run all the wires when i put the new dash in? i have never done anything like this before i am notg sure if i will be able to put it back together again once i get it all out. kinda sucks. and does anyone know if a 1995 cab will fit on a 1999 truck frame?
#17 of 30 Driver's Side Seat Removal
Aug 26, 2008 (9:32 am)
Hello all. I have a 2002 Ranger and I need to remove the driver's side seat, since I broke the reclining bolt. Does anyone know what size Torx bit I need? Also, does anyone know if the seat is connected to the airbag system?
#18 of 30 want to pimp my ride
Sep 14, 2008 (2:42 pm)
I'm ready to spruce up the interior in my 1996 ford ranger splash. I want to replace upholstery and the seats. Anybody have experience with this? Where is a good place in the Mobile, AL area to have it done? How much will it cost?
#19 of 30 Replacement Seat 1995 Ranger
Mar 02, 2010 (4:44 pm)
#20 of 30 Replacement Seat 1995 Ranger
Mar 02, 2010 (4:44 pm)
Has anyone replaced the 60/40 seat in the 95 or similar Ranger? I would like to locate a grey seat in good condition, any suggestions?
#21 of 30 interchangeable seats
Mar 21, 2010 (12:19 pm)
I have a 1996 Ranger regular cab and it has a bench seat. I would like to know if I can get a 60/40 seat from any other years to put in easily? Also, has anyone figured out why the dome light stays on all the time. I am sure many others have had this problem. Also the buzzer stays on when I put the key in the accessory position?
#22 of 30 Re: interchangeable seats [xramarx]
Mar 22, 2010 (1:05 am)
The 'door open' switches are bad.
You have to take the door panels off. They are not on the hinges, they are on the locking/door closing mechanism, up on the inside rear. Take the panel off and find the wire. Replace the switch or clean it up with WD40, etc.
You might have one or both door switches bad.
#23 of 30 Re: interchangeable seats [xramarx]
Nov 10, 2010 (7:17 pm)
look as far as the dome light all you have to do is spray ALOT of WD40 into the door latch. that is where the sensor is and it has worked for me and my ranger comrades.
Nov 19, 2010 (4:42 am)
does any one know any good site to look at for finding stuff to redo the inside of my truck my self
Jul 03, 2011 (5:20 pm)
i have a 1999 ford ranger, and had this problem, i went to the parts store and the guy tried to get me to buy a sensor, i was then going to adjust the latch the door hooks onto, instead i heard about WD40 working, i shot it in there and sure enough it worked like a champ, no problems since!