You are here:
Forums
Vans & Minivans
Chrysler/Plymouth Voyager, Dodge Caravan
Dodge Caravan/Plymouth Voyager Cooling System (radiator, fan, etc.)

51 messages, Last post on Jul 16, 2009 at 1:40 PM
You are in the Chrysler/Plymouth Voyager, Dodge Caravan Forum. Your Host is Karens
|
Hi- for replacement; Does any one know where the cooling fan (electrical)relay module is located.? Most repair manuals leave out its location. |
|
|
Replying to: pmary (Jan 16, 2007 2:11 pm)
|
|
|
Hi, folks, I've moved the drum removal posts to our existing brakes discussion, where they'll have a better chance of being noticed and answered: 2001 - 2006 rear drum removal by bobconstance |
|
|
Replying to: pmary (Jan 16, 2007 2:11 pm) After much searching I found the Relay resting on top of the front bumper (rail frame re-bar) in behind the grill on the driver's side.To access it you will need to remove the head lamp (3 screws) module.The Relay is attached (factory installed)by a large rivet. A large pry bar may be required to free the faulty relay. Remove the wiring harness with a small hooked flat screwdriver under the (hidden) inside area of the locking tab. Before re-connecting put a spot of vaseline on each tab of the new module to reduce moisture corrosion.The Relay has to be firmly re-attached to the bumper to create a heat sink.You will need to remove the rivet from the bumber with a long cold chisel and re-attach the new module with a 9/32" self tapping large screw (or see dealer's replacement part). Re-attach the wiring harness before re-attaching the module to the bumber.Make sure it is well secured- the radiator is right behind it!
|
|
|
Replying to: pmary (Jan 18, 2007 7:26 am) The 9/32" self tapping screw just wouldn't cut it. I wound up tapping the hole with a 5/16" NC 16 tap bit mounted from a small T bar tap ratchet. I removed a piece of a web from the grill to give me some leverage. Its a very tight area in behind the grill to work with but a threaded bolt and lock washer now has the cooling fan relay firmly re-secured. I think a secure mount might work as a ground for the circuit as well so a tight installation with no loose play is a must. Be careful not to tighten the bolt too hard or you may strip the (2) threads in the hole. Some thread lock might be a good idea as well. The cooling fans are now working once again with a warm engine idling while stopped in traffic !
|
|
|
I have a 2006 Grand Caravan with only 2500 miles on it. When our January cold snap hit, I noticed the temperature gauge never gets above the mark JUST BELOW the midline. At first I thought it was because of sub-zero temperatures. Now that it has warmed up into the 40's, it still isn't reaching the midline. Should I be concerned? Steve from Indy
|
|
You are here:
Forums
Vans & Minivans
Chrysler/Plymouth Voyager, Dodge Caravan
Dodge Caravan/Plymouth Voyager Cooling System (radiator, fan, etc.)
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2007 Dodge Caravan
2003 Chrysler Voyager
2000 Plymouth Voyager



Browse by Board
Browse by Topic
Today's Chats