Last post on Jun 24, 2013 at 4:46 AM
You are in the Jeep Wrangler
What is this discussion about?
Jeep CJ-5, Jeep CJ-7, Jeep Wrangler, Jeep Wrangler Unlimited, Auto Repair, Brakes, Engine, SUV
#180 of 349 1997 Jeep Wrangler keeps blowing #11 Fuse and engine dies
Nov 13, 2008 (2:44 pm)
My Jeep would run fine, we just had engine diagnostics done and had o2 sensor replaced. what happens is you can start the jeep but the minuite you put it in gear (auto Tranny) it dies and #11 fues blows then if you try to start it wont crank over put another #11 fuse in and it blows when you try to start jeep. wait a few minuites and put another #11 fuse in and you can start engine but again you try to put in gear it #11 fuse blows and it dies. This has happend earler last month but husband put wire where #11 fuse goes and it would work as normal with #11 fuse. What would cause this? if easier reply to bethannstarkeyyahoo.com
#181 of 349 changing transmission fluid
Nov 13, 2008 (4:40 pm)
I have an all stocked manuel 92 wrangler and am planning on changing out the transmission fluids. since i'm doing that is there anything else i should along with it?
#182 of 349 Re: changing transmission fluid [maaarrk]
Nov 14, 2008 (7:37 am)
It can get pricey, being a '92 you are probably pushing 100,000+ miles, you should look into replacing diff. fluid front and rear, T-case, and breaks if you have the cash, even bleed clutch master cylinder. I would give the dealer a call to find fluid specs just to be sure you have the correct fluid. You don't want to burn the Limited slip on you rear axle. It is not that hard to do but the tranny sits up inside the 'hump' on the floor of the jeep. If you have big hands you barely have enough room to get the fill plug off. Best to buy a pump. Further more the 90w gear oil is very smelly, almost intolerable to me (almost.) Honestly I would just take it to a quick lube place and just pay to have them do it. It moves the liabilty to them and you don't have to dispose of it. It should be about 50 bucks a service. I worked at a Toyota dealership that used B/G products. the 40K is a fuel system cleaner you put in the tank and would place my kids college fund on the line. The stuff is incredibly good. They offer a full line of product to help bring you systems back to life. sorry for rambleing. Good luck.
#183 of 349 Re: changing transmission fluid [agill]
Nov 14, 2008 (7:56 am)
We just had a brand new transmission put in 4 months ago.
#184 of 349 Re: changing transmission fluid [agill]
Nov 14, 2008 (7:58 am)
My Jeep is a 1997, sorry not a 92. But any way thank you kindly for your assistance.
#185 of 349 jeep vacuum hose
Nov 15, 2008 (8:50 pm)
i have a 89 jeep yj with manual transmissiom. a hose has come loose on the motor side of the hose. in other words, the hose is stiil attached to transmission, but i need to know where it attaches on motor. thanks.
#186 of 349 Re: jeep vacuum hose [quidox]
Nov 16, 2008 (1:37 pm)
i believe that there are four hoses on the back side of the t-case. this is what engages the 4x4. Two are vacuum supply, probably comes from intake manifold, they are responsible for engaging/disengaging t-case. one is like a breather hose and only functions as an air releases and should be routed to fire wall in engine compartment to keep water out. the other goes to the front axle on the passenger side to move the shift fork inside the axle tube, in other words it turns on the front wheels. All vacuum comes from the intake manifold. It hase been so long, i think the colors are red, blue yellow and green. any after market repair manual with vacuum diagrams should help, it has to say that it has vacuum diagrams though, not all books have them. I got mine on amazom for likek $5.00. I almost possative that the only hose on the tranny is just a breather tube also. on my '89 wrangler it was on the fire wall just to the right on the ingnition coil. it looked like it has a little hat on. This in just to prevent stuff from getting in and the only reason that it is on the fire wall is to keep water out of the tranny beside releaving the preasure that can build up.Hope this helps. Oh yeah bve very carefull with vacuum line, The factory ones get very brittle and break easily. I would buy some new vacuum line from parts store before even touching them just avoid having to make a trip.
#187 of 349 fluid changing
Nov 16, 2008 (2:01 pm)
Your owners manual should recommend all the millage's you need to swap out fluids. Just remember off-road usage shortens the life of all your fluids and should be replaced more often. The differential also have breather tube that if come disconnected can allow water and dirt to get into diff housing. If you are fording waterway or submerging deep water or even blasting through little mud puddles all of this increases the possibility of water entering into places you do not want. I personally change my engine oil every 2500-3000 miles. I live in a very dry and sandy area.
#188 of 349 Re: jeep vacuum hose [agill]
Nov 17, 2008 (7:00 am)
Would this cause a fuse to keep blowing? ok we will check this, thank you very much for your assistance.
#189 of 349 Re: jeep vacuum hose [dustie1]
Nov 17, 2008 (7:24 am)
there are no electrical conections involved with the vacuum switch on the transfer case. make sure that you have the correct amp fuse installed first. an after market stereo or navigation, anything that would be spliced into the harness could be possibilities if the are tapped into that power line. Some stereo shop may take short cuts that way. Even a switch that powers any Off Road lights. anything that is not factory install and requires power source. Check that first. Back trance line from souce too. The haynesor chilton manuals have wire digram, too. they are all color coded by jeep to help find wires.