Jeep Wrangler Maintenance and Repair Questions (up to 1996)

348 messages,  Last post on Sep 21, 2012 at 8:15 AM

You are in the Jeep Wrangler Forum.

What is this discussion about? Jeep CJ-5, Jeep CJ-7, Jeep Wrangler, Jeep Wrangler Unlimited, Auto Repair, Brakes, Engine, SUV

#150 of 348 delay in start by lilchappy

Oct 23, 2008 (12:16 pm)

i have a 1993 jeep wrangler and the engine will turn over but wont start right away. It used to take about 5 minutes now i am at about 20. After u turn the ignition on u have to wait 20 min then u can here the relays kick on then the fuel pump as soon as the fuel pump kicks up she stars no problem. I have replaced the relays, the fuel pump, and the ignition switch and am still at the same problem.

#151 of 348 Re: delay in start [lilchappy] by baffled4

Oct 23, 2008 (2:59 pm)

Replying to: lilchappy (Oct 23, 2008 12:16 pm)
I have a 1995 Jeep Wrangler. I had the same exact problem. I also replaced everything like you did. It was my computer, had it replaced about a year ago and no longer have the problem. The mechanic told me the way to check it, when you turn the ignition and the check engine light is not on, your computer is not sending the signals to start the jeep. Mine took twice as long when it was cold or raining, sometimes took an hour to start. I hope this helps!
~Diane~

#152 of 348 Re: delay in start [lilchappy] by ceeotter

Oct 24, 2008 (2:15 pm)

Replying to: lilchappy (Oct 23, 2008 12:16 pm)
I have a 95 Wrangler. When you turn on the ignition b4 cranking it, the check engine light should be on. If it's not, then your computer is bad and needs to be replaced. If your check engine light isn't coming on at first, try turning your ignition on and off several times and watch for the check engine light to come on. It should start when the check engine light comes on. And if that's the scenerio, then your computer is bad.

#153 of 348 1984 CJ7 computer harness by ffelice

Oct 26, 2008 (6:45 pm)

Can anyone tell me where to find a computer harness for my 84 CJ7? I have looked all over and they all point to the Painless wiring harness, but their complete OEM package still won't include the harness going to the computer. The existing harness has been messed with by the previous owner (splices with duct tape). So if anyone has suggestions as to where to get one I would be thankful.

#154 of 348 Re: 1984 CJ7 computer harness [ffelice] by mac24

Oct 27, 2008 (4:58 am)

Replying to: ffelice (Oct 26, 2008 6:45 pm)
This bit?
 

 
There are two complete harnesses on eBay at the moment by the same seller for $150 each.
 
Auction One
 
Auction Two
 
Another solution would be a car breakers.

#156 of 348 76 CJ-7 wont run in on position by quinndog

Oct 27, 2008 (11:20 am)

I have a 76 Jeep CJ-7 that sat for several years, it will start and run in "start position" (starter engaged) but dies in run or on position. I am assuming it must be the ignition switch (key switch). All the gauges and electrical work with the key in the “on” position, it just will not run.

#157 of 348 Re: 1988 Jeep Wrangler Windshield Replacement [mjank] by ronbo2

Oct 30, 2008 (6:44 am)

Replying to: mjank (Jun 22, 2006 11:48 am)
just did it, bring it to a pro it cost me 250 cdn for all new,i am a doit youselfer sometimes it's cheaper to pay i have a 92&94 just did the 94 and they should all be the same outside spacer then there is the rubber on the inside leave it on and buy new rubber for the outside[20 bucks]if you buy the tape adhesive you got one shot good luck to be safe i would say a pro would charge 60bucks and you don;t get dirty

#158 of 348 Re: 1989 jeep wrangler: Emmissions test problem [pwagner] by ronbo2

Oct 30, 2008 (6:50 am)

Replying to: pwagner (Jun 09, 2007 10:02 pm)
it is my understanding that there is a check valve at the back of the motor which causes the oil to blow by thus sending it thru the carb i have heard this but not seen it first hand this i a common problem with 6's
To POST a message, please Sign In.

Advertisement

Browse by Category

Browse by Vehicle
   View All Vehicles

Browse by Board
Browse by Topic
View All Topics

Edmunds Community

Advertisement