You are here: Forums SUVs Jeep Wrangler Jeep Wrangler Maintenance and Repair Questions (up to 1996)

Jeep Wrangler Maintenance and Repair Questions (up to 1996)

261 messages,  Last post on Nov 14, 2009 at 5:12 PM

You are in the Jeep Wrangler Forum. Your Hosts are steve_ & tidester

What is this discussion about? Jeep CJ-5, Jeep CJ-7, Jeep Wrangler, Jeep Wrangler Unlimited, Auto Repair, Brakes, Engine, SUV

Messages Page 27 of 27 1 ... 21 22 23 24 25 26 27 Prev Next Last

Go To Msg # Search This Discussion

#252 of 261 Re: Cooling problems [tsjay] by sonofadocker Sep 24, 2009 (8:03 am)
Replying to: tsjay (Dec 28, 2006 12:07 pm) Afternoon - many many of the Jeep water pumps have an impellor ( moves the coolant) that is made a abs plastic. This, when the impellor starts to fail it does not hold its shape and move the coolant. please look at all the other suggestions - coolant hoses that collaspe when hot - old thermostat etc.   but most jeep motors that i get that have blown head gaskets have BAD water pumps.
#253 of 261 Re: FYI-exhaust [agill] by firemandelapp Sep 25, 2009 (4:53 pm)
Replying to: agill (Nov 06, 2008 9:27 am) i have a jeep wrangler 1993.runs great but just recently after extend drive time it will stumble and stall after you let it sit for a while it starts right up and runs great.help
#254 of 261 96 Jeep Wrangler Spins but won't crank immediately by jeepers60 Sep 27, 2009 (11:12 am)
When I turn the ignition to crank the 4.0L it spins but will not attempt to crank for up to 7-8 attempts. It will finally crank and when it does it runs fine, but I'm hesitant to venture out very far. You can kill it and it will restart after 2-3 attempts, if the restart is within minutes of killing it. When I turn the ignition on I get all of the check lights and instrument activity like normal. Does this sound like a fuel pump or fuel filter issue? Replies to this message: ceeotter (Sep 27, 2009 3:28 pm) jeepers60 (Sep 28, 2009 6:07 pm)
#255 of 261 Re: 96 Jeep Wrangler Spins but won't crank immediately [jeepers60] by ceeotter Sep 27, 2009 (3:28 pm)
Replying to: jeepers60 (Sep 27, 2009 11:12 am) It sounds like it's your selenoid that sits on your starter. The selenoid is what causes your starter to engage the flywheel when you turn the key. Replies to this message: jeepers60 (Sep 28, 2009 6:07 pm)
#256 of 261 Re: 96 Jeep Wrangler Spins but won't crank immediately [ceeotter] by jeepers60 Sep 28, 2009 (6:07 pm)
Replying to: ceeotter (Sep 27, 2009 3:28 pm) No, the starter is engaging and the engine is turning over but it won't crank for 7-8 attempts. It is like it is lacking fire or fuel. Like I stated the check engine light comes on when I turn on the ignition so I don't suspect the computer as the problem. The puzzling thing about this is when it finally cranks it runs just fine. I am a little uneasy to venture to far for fear that it may not crank on the 7th or 8th try one day. It has always cranked quickly and easily. Does this even resemble a fuel pump or fuel filter problem. Please advise.
#257 of 261 Re: 1988 wrangler [dutch8006] by gouche Oct 02, 2009 (7:06 pm)
Replying to: dutch8006 (Feb 01, 2007 5:32 pm) I have a 1988 Yj getting ready to install a weber carb. with fuel regulator, then a new distributer, had a friend with same set-up but lost his number,I think if someone can send me some pictures of same set-up, I would be most greatful.greggoucheaol.com
#258 of 261 1988 yj by gouche Oct 02, 2009 (7:19 pm)
need pics of a weber carb. actually installed for view, so I can attempt to install,anybody with any pictures please,like a birds eye view, 360 degrees or other,thanks greggoucheaol.com for e-mail
#259 of 261 Jeep Master Cylinder Location by davedenn Oct 03, 2009 (4:07 pm)
I have an 83 CJ-7 that has a T-5 Warner trans. I am attempting to locate the clutch master cylinder that I have been told should be on the vehicle. I can't find it! Can anyone give me a clue where to look? The manual (Chilton) says it is under the hood, but I don't see anything that looks even vaguely like the picture of the thing.   Thanks,   Dave
#260 of 261 1996 Jeep Wrangler--By pass auto kill switch by dustie1 Oct 16, 2009 (3:00 pm)
Is there any way to bypass the automatic kill switch, I would like to start my Jeep and keep it running. My Jeep is an automatic is the kill switch internal or external this is also 4 cyl as well. We need to bypass the auto kill switch so we can read the codes to see what's wrong with it. Any help would be great.
#261 of 261 86 CJ Wiper Question by davedenn Nov 14, 2009 (5:12 pm)
I have an 86 CJ7. The windshield wipers park rather high on the windshield instead of near the bottom. Is there an adjustment either on the motor or the wiper linkage that can be adjusted so they park near the bottom of the windshield?   Thanks for all your help in the past, you're all great people!   Dave

Messages Page 27 of 27 1 ... 21 22 23 24 25 26 27 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums SUVs Jeep Wrangler Jeep Wrangler Maintenance and Repair Questions (up to 1996)