Edmunds.com | Inside Line | Auto Observer Your Account | Help | Directory
You are here:
![[F]](http://a332.g.akamai.net/f/332/936/12h/www.edmunds.com/media/townhall/webxicons/site.gif){kind=small}
Forums
SUVs Jeep Wrangler Jeep Wrangler Maintenance and Repair Questions 2007 and newer
157 messages, Last post on Nov 08, 2009 at 2:54 PM
You are in the Jeep Wrangler Forum. Your Hosts are steve_ & tidester
|
|
|---|---|
|
Replying to: flynlevel (Jun 02, 2008 8:28 am) Clearly this is a defect in the product that Jeep has not figured out yet. Good luck! |
|
|
Replying to: kellykay474 (May 21, 2009 7:08 am)
|
|
|
Replying to: skyking49 (Jun 03, 2009 9:05 am) EBC Yellowstuff brakepads will be all the pad your TJ will need unless you really build up your Jeep. -Paul |
|
|
Replying to: kellykay474 (May 21, 2009 7:08 am) For a vehicle that is meant to be driven "rough" it is a joke to have them go bad so often.
|
|
|
Replying to: skyking49 (Jun 10, 2009 1:30 pm)  If you run larger tires with a lift, the TJ brakes quickly become inadequate. Vanco makes a brake upgrade kit that uses dual piston calipers vs the single caliper on the TJ's. Better rotors and grippier pads, combined with that brake upgrade make for an incredible setup. Also note, if you ride your brakes a lot or tap them any time you need to slow down, you increase your chances of warping. I saw that a LOT on the California highway/parking lots. Yet I managed to get over 66,000 miles from stock Jeep brakes on my Grand Cherokee (WJ) when they were known to warp even easier than the TJ's will. Sure the brakes could be better, but driving habits will dictate SOME of it (though it doesn't really apply if they warp w/in 2 weeks of vehicle delivery). -Paul |
|
|
Replying to: dldjeep01 (Oct 30, 2007 5:48 pm) |
|
|
|
|
Second oil change. Valvoline dino out. Valvoline syn in (should I dope it with some group V only I know). Noticed tire feathering front to back. No authorized local dealer has a service writer or service person driving a wrangler. One dealership accused me of not rotating my huge mudders (stock rubi's) every 3k miles and I should expect that kind of wear. Warranty smarranty. Back to Screamin Lizard - immediate answer - alignment. Caster out, toe out - but the funny part is that there was no shimmy no pulling nothing not even when close to the rev limiter while taking a long banked interstate curve. Complete confidence. However, the cross camber, cross caster, and cross toe were all within specs. Ordered an aftermarket steering stabilizer and bracket from the 'Lizard as preventative maintenance. Almost got tboned on passenger side thankfully no passenger. Made it through the intersection before their brakes stopped them in the middle as seen in my rearview. Moving up the frame mounted step idea, leaving rubi rail on, to increase the side protection (airbags can only do so much). Was asking the 'Lizard to custom make some but investigating a frame mounted step now. Yes, I spent way too much time reading about the ins and outs of body/frame/combo rails. Want frame mounted and the body mount locations look good for now but want something soon. While better_half likes her H3 it really runs great now redline everywhere and smoother tires, the wrangler truly is an enjoyable sport car 4x4 and she wants to pry the key out of my hand every chance she can take. Rockhard cannister cover-didn't relocate. Mirror drain holes after second hand washing. Redline in dif's. Steering stabilizer coming. Steps coming. Should've been in Bridgeport yesterday-Oh well October then. |
|
|
|
|
Replying to: brokenjeep (May 28, 2009 10:32 am) first i thought it had something to do with my ABS brakes and the recalls they had for the computer software the first time Chrysler told me it was the tires with out even looking at it the second time they couldn't duplicate the problem I am now going on 6 times I fear bridges and tunnels because if it happens there I am certainly getting rear ended any suggestions on what to do after reading this forum it seems there is no solution
|
|
|
|
|
Replying to: olivejeep (Sep 26, 2007 8:16 am) |
|
|
Replying to: curreriedward (Sep 22, 2009 11:55 am) Wranglers up the '06 sometimes have this problem too, and in those cases it's almost always a combination of worn steering joints and a suspension lift. However, from '07 onward it seems to have become a design issue occurring on even brand new vehicles. What makes it harder for the customer is that it doesn't occur on all vehicles, and even on those that suffer it doesn't occur consistently. AFAIK there's no official fix, but some people have had dealers fit aftermarket steering stabilizers under warranty, which is the route I'd follow if it were mine. Try to get a pair of the beefiest stabilizers installed that you can find, even if you have to pay for it yourself. It will mask rather than fix I'm afraid, but until Jeep publicly recognize the problem and design a fix it's the best I can offer. Personally, I think that Jeep will ignore it, just as they have with the leaking hardtop issue. |
|
You are here:
Forums
SUVs Jeep Wrangler Jeep Wrangler Maintenance and Repair Questions 2007 and newer
New? Join Now!
Forum Tools
Search Forums
Browse by Vehicle
2010 Jeep Wrangler
Browse by Board
Browse by Topic
