You are here: Forums Hatchbacks Chevrolet Metro/Geo Metro Geo Metro Electrical Problems

Geo Metro Electrical Problems

10 messages,  Last post on Jan 17, 2009 at 1:05 PM

You are in the Chevrolet Metro/Geo Metro Forum. Your Host is pf_flyer

What is this discussion about? Geo, Geo Metro, Electrical, Hatchback

Messages Page 2 of 2 1 2 Prev Next Last

Go To Msg # Search This Discussion

#9 of 10 Re: 92 Metro convertible charging problem [blueknight2] by zenden Jan 03, 2009 (5:36 pm)
Replying to: blueknight2 (Dec 30, 2008 2:40 pm) I would say that it has bad diodes in the alternator. this is most likely the reason that you had to replace the bat in the first place. If the diodes are bad in the alternator the voltage drops, it must produce 13.7 volts to charge that bat properly. Because the diodes are bad and the bat is new, you will not often see any trouble with the system, only when you discharge the bat to far for it to recover with that week alt. To prove that you have this problem with bad diodes get a dc volt meter start the car and turn everything on! create a full load on the system! then hook up your volt meter to the bat if it reads less then 13.7 volts then your alternator is BAD! As long as you never drain that bat down below 30 percent charged this monster will never leave you broak down; but once that bat becomes 2 or 3 years old the alternator will not be stronge enough to charge it up enough to keep you going. Your alt has 6 Diodes, they burn out for 2 reasons! (1) age!, or (2) giving or getting a hot shot! An alternator produces (AC) alternate currant; a bat will only take a charge from (DC) direct currant. The diodes convert AC to DC; they are delicate, and are like a one way valve, making the elect. flow one way only. When 2 car are connected together by jumper cables; one is running and the other one starts the 2 DC come together and blow out the delicate diodes; then the Volts drop below the needed 13.7 that it takes to properly charge a 12 Volt bat. in any car.  I hope that this helps you!
#10 of 10 car wont start 97 geo 1.3l by bogeyplyr Jan 17, 2009 (1:05 pm)
i got voltage to ignition coil but not sure how much hardly nothing at spark plugs tried two sets of wires different distr. different rotor, diff. cap different engine. im assuming crank shaft sensor wiring problem or pcm problem any help please!! How do i check voltage to cps and how do i check pcm to se if it is working properly.

Messages Page 2 of 2 1 2 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Hatchbacks Chevrolet Metro/Geo Metro Geo Metro Electrical Problems