Last post on Nov 16, 2013 at 2:51 PM
You are in the Ford Expedition
What is this discussion about?
Ford Expedition, Heating / Cooling
Dec 05, 2010 (6:11 pm)
I have the same truck , same problem i did the flush and it didn't work at all then the repair shop told me my heater core is bad and so is my blender door motor.... they change my temp gauge and water pump .... nothing worked ... my truck is so cold i brought an portable heater ......
#94 of 145 Re: 98xlt [kira98expo]
Dec 06, 2010 (10:14 am)
What type of portable heater did you buy?
#95 of 145 Re: 98xlt [ksoren]
Dec 06, 2010 (12:30 pm)
actually i brought two one at target for ten buck that's for the home but i run an extension cord from my house to my truck to warm the inside , then at advance auto they have the portable that plugs into the lighter socket ... for 23 dollars but u need at least three just to have warm heat........
#97 of 145 Re: 98xlt [kira98expo]
Dec 06, 2010 (12:49 pm)
I had looked into the DC type heaters. I figured with there output it wouldn't be worth it because we usually only need heat early in the morning here in Las Vegas, NV. It gets pretty cold in the early morning so I have an small shop blower hearter I run an extension cord from garage to the truck which really helps.
Thanks for the info.
#98 of 145 Re: 98xlt [ksoren]
Dec 06, 2010 (7:43 pm)
I hope this works for u ..... let me knw
#99 of 145 ac blowing
Dec 11, 2010 (3:05 pm)
My AC is blowing on high and I can't turn it off or down??
#100 of 145 Re: 99 expedition no heat [ksoren]
Dec 26, 2010 (9:37 am)
I'm having the same problem as everyone else on my 98 expedition; No heat front or back. Blend door is working fine. Swapped the thermostat but I noticed my heater hoses aren't getting hot or even warm. I was planning to flush the heater core but can't figure out how to access the hoses. Any suggestions? Photos or video would be helpful.
#101 of 145 Re: 99 expedition no heat [bart501]
Dec 26, 2010 (10:48 am)
Usually the flush kits T into the lines at the fire wall. Last time I saw one it was a Prestone product, but I'm sure others make them.
#102 of 145 Re: 99 expedition no heat [alwaysfords2]
Dec 26, 2010 (11:30 am)
I have one of those but I only want to flush the heater core(s), not the entire engine. Also it's a tight fit trying to get one of the t-fittings on one of the hoses coming out of the wall.