Sign In Join 



Ford Expedition Climate Control Problems

58 messages,  Last post on Dec 04, 2009 at 10:58 AM

You are in the Ford Expedition Forum. Your Hosts are steve_ & tidester

What is this discussion about? Ford Expedition, Heating / Cooling


Messages Page 5 of 7
1
2
3
4
5
6
7
Prev
Next
Last
Go To Msg #
Search This Discussion

#33 of 58
Re: Expedition switches from the panel to the defrost vents when engine is rev. [killbinladen] by zoomzoomn
Mar 11, 2008 (5:37 am)
Reply

Replying to: killbinladen (Jul 03, 2007 3:24 pm)

There are a number of areas that you need to check for vacuum leaks. From the head unit (the controls) to the canister in the engine compartment. It could even be a small evap leak elsewhere that is keeping the system from maintaining enough vacuum under high load conditions.
#34 of 58
Re: gas fumes [tony66] by tony66
Mar 20, 2008 (2:57 pm)
Reply

Replying to: tony66 (Dec 06, 2007 6:51 am)

found the problem after 6 months steel spark plugs into aluminum block when you change them have to get all carbon out or they will not seal right
#35 of 58
2006 Expy, no heat to rear/roof vents by markm828
Jan 22, 2009 (9:37 am)
Reply
I'm able to get great heat from the front but no heat makes it out the roof vents. same holds true for A/C. i noticed some folks mentioned the blend door as a possible issue. Would that cause this problem? is this a dealer repair or is it something that can be fixed/accessed easily?
 
Thanks for any input
#36 of 58
08 Ford Expdition Heated Seats-Not Warm Enough by Island601
Feb 14, 2009 (1:47 pm)
Reply
I have recently purchased a used 2008 Ford Expdition Eddie Bauer from a dealer with 12K on it. My problem is that the heated seat work OK, but do not get as warm as my old 2001 Chevy Tahoe seats. It seems that the back of the seat is warmer than the base of the seat. I have not talked to the dealer yet, but will on my first oil change coming up soon. Anybody else had experience with not warm enough on the heated seats?
#37 of 58
06 expedition blower motor runs on high speed only by rjw3
Feb 17, 2009 (4:14 pm)
Reply
I was told the blower motor heater module is what changes the blower motor speed and when it goes bad, the blower motor only operates on the high speed switch setting. Would anyone be able to confirm this and if correct, walk me through where this resistor module is exactly located. Thanks in advance.
#38 of 58
Intermittant Front Heat...Rear Heat Excellent! by 99bauer
Feb 17, 2009 (4:40 pm)
Reply
I just bought a 1999 Eddie Bauer Expedition and I see that my problem is common. I will get "warm" heat out of the front floor and cold from the defrosters at the same time..or cold from both. This has the auto Climate Control and I can change temps from "warm" to AC and it will change and blow cold but it wil not heat.. drove it 40 miles one way and NO HEAT!! Rear controls work awesome!! I keep seeing people talking about this but have not seen any solutions short of taking it your dealer and get raped!
#40 of 58
Heater Control by flyinghigh2
Apr 24, 2009 (5:52 pm)
Reply
One morning it was 50 degrees and I set my heater control to hot. The next day I tried to set it for 'cool' outside air and found it remained hot. Since then, it has stayed hot no matter where I dial my Hot/Cold selector to. I don't use my air conditioning much because I keep it on the PANEL selection when I want to save gas. Now, I can't even get my air conditioning to cool my 1999 Expedition interior down. I get hot air no matter what. My buddy says that the 'electric switcher' that controls the heater door may be faulty(causing the heater door to remain open) or I may have a broken shaft that the motor turns. When I turn the hot/cold dial, I hear nothing. No clicking, nothing. I try my dash panel selector and it changes to the appropriate venting, floor, windshield, etc. But stuck on HOT for some reason. Could my relay in my fuse block be bad? Please help me to find the fault. Thanks. Scott
#41 of 58
Blend Door by alwaysfords2
Apr 27, 2009 (3:56 am)
Reply
Sounds like a broken blend door. that's a big job - the dash has to come out. There is an aftermarket kit for this that you need to cut the back of the glove box out for - i think it is called Heater Treater or something like that.
#42 of 58
Re: Blend Door [alwaysfords2] by steve_ HOST
Apr 27, 2009 (9:12 am)
Reply

Replying to: alwaysfords2 (Apr 27, 2009 3:56 am)

The other one is Blen Dor. Both outfits hang out on the forums here trying to, er, market their stuff without running afoul of our no-soliciting or self-promotion rules. You can find both on eBay.

Messages Page 5 of 7
1
2
3
4
5
6
7
Prev
Next
Last
Go To Msg #
Search This Discussion
To POST a message, please Sign In.

New? Join Now!

Forum Tools

Please sign in.
Email Address:

Password:

Forgot Password?

Search Forums

Enter Keyword(s)

Advanced Search

Browse by Vehicle



View All Vehicles
Advertisement
Ask the Community
See What People Are Asking

Browse by Board

Browse by Topic


View All Topics

Today's Chats

Advertisement