You are here: Forums Vans & Minivans Nissan Quest Nissan Quest Radiator/Coolant System

Nissan Quest Radiator/Coolant System

17 messages,  Last post on Nov 02, 2008 at 4:57 AM

You are in the Nissan Quest Forum. Your Host is Karens

What is this discussion about? Mercury Villager, Van

Messages Page 3 of 3 1 2 3 Prev Next Last

Go To Msg # Search This Discussion

#14 of 17 Bleeding the cooling system by jeffgc Jul 28, 2008 (9:03 pm)
Does anyone know where the air relief cap for the heater pipe is on a 1994 Nissan 3.0 V6I need to bleed the cooling system and the manual says to" find the air relief cap for the heater pipe, connect a 1/4" hose to the air relief fitting and insert the other end of the hose into the coolant reservoir. I can't find it - anybody know? thanks, jeff
#15 of 17 Re: overheating and loss of coolant [jharrison120] by jharrison120 Aug 09, 2008 (1:53 pm)
Replying to: jharrison120 (Jul 19, 2008 8:26 am) It was the waterpump, the coolant was coming from the bottom seep hole in the waterpump. The condition of the belt was poor. I changed the timing belt at the same time as the waterpump because the lower timing belt cover has to be removed to access the pump. I also changed the ac belt, waterpump belt, alternator belt, and the thermostat. It cost me $188 for all the parts, and my labor was free lol. the tools i needed : 3/8 ratchets, and extendtions, 8mm, 10mm, 12mm sockets. 1 1/16 socket, 1/2 impact gun, and steering wheel type puller for the crankshaft pulley. I also used a 5/8 spark plug socket to remove no 1 plug to check for top dead centre. Thats about it. hope this helps somebody. Replies to this message: pastorck (Aug 31, 2008 12:56 pm) jharrison120 (Nov 02, 2008 4:57 am)
#16 of 17 Re: overheating and loss of coolant [jharrison120] by pastorck Aug 31, 2008 (12:56 pm)
Replying to: jharrison120 (Aug 09, 2008 1:53 pm) Is the 1/2 impact gun you used in a shop with over 120psi or is it another type? I have my car on the drive way and failing to remove the crankshaft pulley. Any suggestions to hold the pulley from moving? Replies to this message: jharrison120 (Nov 02, 2008 4:57 am)
#17 of 17 Re: overheating and loss of coolant [pastorck] by jharrison120 Nov 02, 2008 (4:57 am)
Replying to: pastorck (Aug 31, 2008 12:56 pm) I used an electric impact gun and a steering wheel type puller, you might be able to use a ratchet with the puller.

Messages Page 3 of 3 1 2 3 Prev Next Last

Go To Msg # Search This Discussion

You are here: Forums Vans & Minivans Nissan Quest Nissan Quest Radiator/Coolant System