Last post on Oct 27, 2013 at 2:46 PM
You are in the Chevrolet TrailBlazer
What is this discussion about?
Chevrolet TrailBlazer, Electrical, SUV
#3 of 13 Re: keyless system not working 2005 trailblazer [timmyjoe]
Jan 04, 2007 (7:06 pm)
2002 Chevy Trailblazer here. I have the same problem, keyless remote not activating. I think it is most likely a fuse, but am afraid to explore it, much too complicated for someone average like me. I "think" the keyless fusebox is under the rear passenger seat, when my mind gets around to it, I will try to look at it. Anyone else who is successful at it, email me at natd767yahoo.com. Thanks!
#4 of 13 Re: keyless system not working 2005 trailblazer [natd7677]
Sep 12, 2007 (7:41 am)
I have the same problem with mine also. I tried to look at the fuses underneath the back seat but i really didn't find anything. The other day i noticed another fuse box underneath the hood. I haven't had a chance to look in there yet but I'm wondering if the bad fuse is in there. This had happened to me twice. The time before it happened for a few months and then all of a sudden it started working again. Then once again it cut back out. My dad said it might be a loose wire, but i don't know. If anyone figures it out, let me know.
#5 of 13 Re: keyless system not working
Sep 13, 2007 (8:57 am)
There have been some problems with the wiring harness from from the top of the liftgate into the roof where it flexes and bends every time the liftgate is opened and closed. The ground wire breaks which will disable the RKE (the module is in the liftgate) with the wiper, and the power lock mechanism. The license plate lights will be dead too when that ground is open. Everything electrical in the liftgate shares a common ground.
#6 of 13 Re: keyless system not working 2005 trailblazer [timmyjoe]
Sep 20, 2007 (12:38 am)
I had this problem too
I repaired like this for .10 $
Look at the backdoor
inside you have a motor ( black )with a little white arm
at the end of this arm, a part like a black pill
slide out of his case, this is why the keyless fail.
I did a little hole
and place an aluminium plate over this black part
to keep it in
buy a bold size 2 or 3
with a lock nut
excuse my poor english
#7 of 13 Re: keyless system not working 2005 trailblazer [kabak]
Sep 24, 2007 (2:57 pm)
Interesting. Good illustation btw...
So that arm comes out of the motor where it should nomally be connected, and then won't unlock the latch mechanism? That arm goes over to the latch that's operated by the outside handle?
#8 of 13 Re: keyless system not working 2005 trailblazer [tblazed]
Sep 25, 2007 (6:56 am)
That arm goes over to the latch that's operated by the outside handle?
all this system goes with outside handle
it's there to move some pins to stop the handle
and windows's button to move !
if you look inside the car ( lift the backdoor )
remove the little round plastic cover at the bottom
of the backdoor
you will see the white part of the motor
( electric connexions )
at the right end of the white arm you have this little black piece how is pushing to do rotate (x - y axe )a grey part
usualy it stay well, but sometime the white arm
can't because the black piece slide so easily.
remove a bolt under the belt how close the door
remove the inside cover of the backdoor
and 4 bolts under the door as shown in first image
do a little hole .... red ......in the yellow part
you have the place to do a hole whitout touching at the arm
do a aluminium plate..........green
with same holes
buy a little bolt ( sz 2 or 3 ) with lock nut
and install like before the last image
excuse my english
and I hope you will understand
but the garage asked me 400.oo$ to repair the keyless system
with perseverance it's costed me a bolt and nut
and free time
#9 of 13 Re: keyless system not working 2005 trailblazer [kabak]
Sep 25, 2007 (10:42 am)
That's very nice! Did you create the graphics yourself? I'm impressed.
Consider writing up a Guide
SUVs and Smart Shopper
#10 of 13 Re: keyless system not working 2005 trailblazer [tidester]
Sep 26, 2007 (5:57 am)
Did you create the graphics yourself ?
yes, It's easy when you know a bit ' Sketchup '
soft for make 3d drawing
#11 of 13 New to the Group- Cruise Control
Aug 01, 2013 (11:52 pm)
Hi there, Just bought a 2006 T/B LT Extended 4.2 Engine. Still exploring it.
Have 3 questions:
1- When I engage the Cruise control, it works fine but NO LIGHT on the panel appears that can tell me it is engaged. The cruise works but the status light is not there. Is it common?
2- I heard of Stabilitrack system. Not sure where is the button to disengage it. Please help.
3- My TB doesnt have a DIC (Driver Info Centre). Means doesnt have the buttons on steering wheel. I heard I can adjust some parameters (Auto Headlamps Off time etc.) Can someone advise me how can I make this customization without having DIC in my TB? Can I do it with a computer or a diagnostic tool?
4- I dont know what is my Gear Ratio to let me find out what load I can tow. Can someone help me how can I find it?
5- I got only One key with the car. Can I simply duplicate it? does it have any chip inside?
By the way, I drove it first time today and got a good gas mileage. Made a 424km trip in 43 Litres.